User manual WHIRLPOOL GCXP 71102 A INSTRUCTION FOR USE

[. . . ] IMPORTANT SAFETY INSTRUCTIONS READ ALL THE INSTRUCTIONS BEFORE USING WARNING: When using your dishwasher, follow the precautions listed below: GROUNDING INSTRUCTIONS • This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of anelectric shock by providing a path of least resistance of electric current. This appliance is equipped with a cord having an equipmentgrounding conductor and a grounding plug. • The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances. WARNING: Improper connection of the equipment-grounding conductor can result in the risk of an electric shock. [. . . ] with the opening downwards so that water cannot collect in the container or a deep base. WARNING: It is dangerous to open the door when washing, because the hot water may be scalded to you. The door should not be left in the open position since this could present a tripping hazard. 45 STARTING A WASHING PROGRAMME Wash Cycle Table NOTE Meaning: need to fill rinse into the Rinse-Aid Dispenser. • • * En50242: This program is the test cycle, the rinse-aid dispenser setting is recommended to be set to position 6. • The power consumption of off-mode is 0W, left-on model is 0. 73W. Cycle selection information For all soiled loads, such as pots, pans, casserole dishes and dishes that have been sitting with dried food on them for a while. For heaviest soiled crockery, and normally soiled pots pans dishes etc with dried on soiling; Program Description Detergent Running of cycle pre/main time (min) Pre-Wash AUTOWash Rinse Rinse Drying Pre-wash (50°C) Wash (65°C) Rinse Rinse Rinse (55°C) Drying Pre-wash Wash (55 ) Rinse Rinse (65 ) Drying Pre-wash Wash (50°C) Rinse (60°C) Drying Wash (40°C) Rinse Rinse (40°C) Pre-wash Wash (40°C) Rinse Rinse (60°C) Drying Energy (Kwh) Water Rinse (l) 5/22g 120-160 0. 8 - 1. 1 9 - 12 5/22g 120 1. 13 16. 0 Intensive Normal For normally soiled loads, such as pots plates glasses and lightly soiled pans. 5/22 g 155 1. 09 13. 0 Eco. * EN 50242 Standard daily cycle for normally soiled loads, such as pots plates glasses. 5/22 g 160 0. 77 10. 5 A shorter wash for lightly soiled loads and quick wash. Express For lightly soiled crockery and glass Delicate To rinse dishes that you plan to wash later that day. Pre-wash + Intensive + 3 in 1 For the heaviest soiled loads, such as pots, pans, casserole dishes and dishes that have been sitting with dried food on them for a while. 15 g 30 0. 5 9. 0 25 g 95 0. 71 13. 0 Pre-wash 8 0. 01 3. 0 Pre-wash (50°C) Wash (65°C) Rinse Rinse Rinse (55°C) Drying Pre-wash (50°C) Wash (55°C) Rinse Rinse (65°C) Drying Pre-wash Wash (50°C) Rinse (65°C) Drying 3 in 1 1pcs 120 1. 13 16. 0 + Normal + 3 in 1 + Normal + 3 in 1 For normally soiled loads, such as pots, plates, glasses and lightly soiled pans. 3 in 1 1pcs 150 1. 08 13. 5 For lightly soiled loads, such as plates, glasses, bowls and lightly soiled pans. 3 in 1 1pcs 160 0. 84 10. 5 46 Turning On the Appliance Starting a cycle wash 1. Draw out the lower and upper basket, load the dishes and push them back. It is commended to load the lower basket first, then the upper one (see the section entitled Loading the Dishwasher). Pour in the detergent (see the section entitled Salt, Detergent and Rinse Aid). The power supply is 220-240 VAC /50 HZ, the specification of the socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure. Open the door, press the ON/OFF button, and the ON/OFF light will turn on. Press the program button to a sired wash cycle. A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may have already been released, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section entitled "Loading the Detergent"). Button more than 3 seconds to cancel the program, then you can change the program to the desired cycle setting (see the section entitled "Starting a wash cycle …"). Button more than 3 seconds to cancel the runing program, translase the program which you press. Press the display button more than 3 seconds to re-edit display time. [. . . ] The programme was not powerful enough. Not enough detergent was Use more detergent, or change your detergent. Items are blocking the path of spray arms. Rearrange the items so that the spray can rotate freely. The filter combination in Clean and/or fit the filter combination orrectly. Clean the base of wash cabinet is the spray arm jets. [. . . ]