User manual WHIRLPOOL GGE390LX INSTALLATION

[. . . ] Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] 4 cm) of slack in the line so that the range can be moved if servicing is ever necessary. A UL listed conduit connector must be provided at each end of the power supply cable (at the range and at the junction box). Wire sizes and connections must conform with the rating of the range. the wiring diagram is located on the Tech Sheet. The Tech Sheet is located on the back of the range inside a clear plastic bag. Failure to do so can result in death, fire, or electrical shock. If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate and wire gauge are in accordance with local codes. Be sure that the electrical connection and wire size are adequate and in conformance with CSA Standard C22. 1 , Canadian Electrical Code , Part 1 - latest edition , and all local codes and ordinances. A copy of the above code standards can be obtained from: Canadian Standards Association 178 Rexdale Blvd. Toronto, ON M9W 1R3 CANADA Check with a qualified electrical installer if you are not sure the range is properly grounded. This range is equipped with a CSA International Certified Power Cord intended to be plugged into a standard 14-50R wall receptacle. Be sure the wall receptacle is within reach of range's final location. *The NEC calculated load is less than the total connected load listed on the model/serial rating plate. **If connecting to a 50-amp circuit, use a 50-amp rated cord with kit. For 50-amp rated cord kits, use kits that specify use with a nominal 1³/" (34. If range height adjustment is necessary, use a wrench or pliers to loosen the 4 leveling legs. This may be done with the range on its back or with the range supported on 2 legs after the range has been placed back to a standing position. NOTE: To place range back up into a standing position, put a sheet of cardboard or hardboard in front of range. Using 2 or more people, stand range back up onto the cardboard or hardboard. Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. [. . . ] Place level on oven rack and check levelness of range, first side to side; then front to back. Use ³/" nut driver to connect the bare (green) ground wire to the center terminal block post with one of the 10-32 hex nuts. If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket. Use wrench to adjust leveling legs up or down until range is level. [. . . ]