User manual WHIRLPOOL GGG390LXS

[. . . ] Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] 3 cm) male pipe thread is needed for connection to the female pipe threads of the inlet to the appliance pressure regulator. Do not kink or damage the flexible metal tubing when moving the range. 6 m), ratings are reduced at a rate of 4% for each 1, 000 ft (304. 8 m) above sea level (not applicable for Canada). Must include a shutoff valve: The supply line must be equipped with a manual shutoff valve. This valve should be located in the same room but external to the range opening, such as an adjacent cabinet. It should be in a location that allows ease of opening and closing. The valve is for turning on or shutting off gas to the range. Gas supply pressure for testing regulator must be at least 1" water column pressure above the manifold pressure shown on the model/serial rating plate. Line pressure testing above ½ psi gauge (14" WCP) The range and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of ½ psi (3. Line pressure testing at ½ psi gauge (14" WCP) or lower The range must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ psi (3. Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. Remove oven racks and parts package from inside oven. To place range on its back, take 4 cardboard corners from the carton. stack one cardboard corner on top of another. Place them lengthwise on the floor behind the range to support the range when it is laid on its back. Using 2 or more people, firmly grasp the range and gently lay it on its back on the cardboard corners. Using 2 or more people, stand range back up onto cardboard or hardboard. When the range is at the correct height, check that there is adequate clearance under the range for the anti-tip bracket. Before sliding range into its final location, check that the antitip bracket will slide under the range and onto the rear leveling leg prior to anti-tip bracket installation. Remove the anti-tip bracket that is taped inside the upper oven with the package containing literature. [. . . ] IMPORTANT: You may have to adjust the "LO" setting for each cooktop burner. Press nut driver down onto the Natural gas orifice spud and remove by turning it counterclockwise and lifting out. Use the following chart for correct LP gas orifice spud for each burner. Refer to the model/serial rating plate behind the control panel for proper sizing of LP gas orifice spuds for each burner location. [. . . ]