User manual WHIRLPOOL GI15NDXZB INSTALLATION GUIDE

[. . . ] Use a receptacle which cannot be turned off by a switch or pull chain. IMPORTANT: If this product is connected to a GFCI (Ground Fault Circuit Interrupter) equipped outlet, nuisance tripping of the power supply may occur, resulting in loss of cooling. [. . . ] If nuisance tripping has occurred, and if the condition of the food appears poor, dispose of it. Water: A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa) is required to operate ice maker and water dispenser. If you have questions about your water pressure, call a licensed, qualified plumber. Reverse Osmosis Water Supply: The pressure of the water coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 30 and 120 psi (207 and 827 kPa). Location: s To ensure proper ventilation for your ice maker, the front side must be completely unobstructed. The ice maker may be closed-in on the top and three sides, but the installation should allow the ice maker to be pulled forward for servicing if necessary. s The floor drains must be large enough to accommodate drainage from all drains. s The ideal installation has a standpipe with a 11/2" (3. 81 cm) to 2" (5. 08 cm) PVC drain reducer installed directly below the outlet of the drain tube as shown. You must maintain a 1" (2. 54 cm) air gap between the drain hose and the standpipe. s It may be desirable to insulate the drain line thoroughly up to the drain inlet. A B A C D 1/" (4. 8 cm) 1" (2. 54 cm) B A. Inlet water tube clamp and supply line connector D. Drain hose (drain pump models only) 23" (58. 4 cm) 2" - 1¹/" (5 cm - 3. 8 cm) C D A. [. . . ] Center of drain should be 23" (58. 4 cm) from front of door, with or without the 3 /4" (1. 91 cm ) panel on the door. The drain should also be centered from left to right (75/16" [18. 56 cm] from either side of the ice maker). Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. [. . . ]