User manual WHIRLPOOL GI6FDRXXY 8-10

[. . . ] If you should experience a problem not covered in TROUBLESHOOTING, please visit our website at www. If you still need assistance, call us at 1-800-253-1301. You will need your model and serial number, located on the inside wall of the refrigerator compartment. Your safety and the safety of others are very important. [. . . ] When the ice maker is on, sensors will automatically stop ice production when the storage bin is full. The ice maker will remain set to ON, and ice production will resume when the bin is no longer full. To manually turn off the ice maker, press TEMP and FAST COOL at the same time and hold for 3 seconds until the "Ice Maker Off" icon lights up. When the ice maker is set to OFF, it will stop producing ice. Pressing and holding TEMP and FAST COOL again for 3 seconds turns on the ice maker and the "Ice Maker Off" icon disappears. To Replace the Ice Storage Bin: IMPORTANT: It may be necessary to turn the auger driver, behind the ice bin, counterclockwise to properly align the ice bin with the auger driver. The ice storage bin must be locked in place for proper ice dispensing. Slide the ice bin into the guide rails located on either side of the enclosure. Use a sturdy container to depress and hold the water dispenser lever for 5 seconds, then release it for 5 seconds. Once water begins to flow, continue depressing and releasing the dispenser lever (5 seconds on, 5 seconds off) until a total of 4 gal. This will flush air from the filter and water dispensing system, and prepare the water filter for use. Additional flushing may be required in some households. As air is cleared from the system, water may spurt out of the dispenser. NOTES: The dispensing system will not operate when the refrigerator door is open. Allow 24 hours for the refrigerator to cool down and chill water. Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. The display screen on the dispenser control panel will turn off automatically and enter "sleep" mode when the control buttons and dispenser levers have not been used for 2 minutes or more. While in "sleep" mode, the first press of a control button will only reactivate the display screen, without changing any settings. After reactivation, changes to any settings can then be made. If no changes are made within 2 minutes, the display will re-enter "sleep" mode. The Water Dispenser IMPORTANT: Dispense enough water every week to maintain a fresh supply. [. . . ] Proof of original purchase date is required to obtain service under this limited warranty. iTEMS EXCLUDED FROM WARRANTY This limited warranty does not cover: 1. Replacement parts or repair labor if this major appliance is used for other than normal, single-family household use or when it is used in a manner that is inconsistent to published user or operator instructions and/or installation instructions. Service calls to correct the installation of your major appliance, to instruct you on how to use your major appliance, to replace or repair house fuses, or to correct house wiring or plumbing. [. . . ]