User manual WHIRLPOOL GKEA 291 OPTIMA PLUS INSTRUCTION FOR USE

[. . . ] 6Gb33004. fm5 Page 1 Thursday, January 25, 2001 4:32 PM PRODUCT SHEET 2 1 1. Area for drawers and pull-out baskets 4. [. . . ] Plug in the appliance Important If the digital display shows only an illuminated dot, press the freezer on/off button B. Six horizontal lines appear on the digital display. After about 3 seconds, when the appliance is warm, (internal temperature above 10°C) only the two lines in the middle remain illuminated; red led F illuminates and the acoustic alarm sounds. The acoustic alarm stops while the red led continues to flash. When the temperature reaches -12°C, the red led automatically stops flashing. 2. Press button E to mute the acoustic alarm. Wait until the temperature indicated on the digital display reaches -12°C. Place food to be frozen and/or already frozen food in the freezer. 5019 603 33004 D GB F NL E P I GR S N DK FIN 6Gb33004. fm5 Page 2 Thursday, January 25, 2001 4:32 PM Freezer compartment temperature adjustment The appliance is normally factory set to operate at the recommended temperature of -18°C. To alter the internal temperature between -16°C and -24°C, proceed as follows: Press button I/a or I/b once to adjust the internal temperature: the digital display shows the temperature previously set. • Each time the button is pressed, the temperature setting is changed by 1°C: the value (between -16°C and -24°C) flashes on the display. • Approximately 5 seconds after the button has been pressed for the last time, the set temperature is stored, the display stops flashing and the current internal temperature is shown on the display. Note: The digital display shows internal temperature values between +10°C and -24°C. [. . . ] To lock the control panel: press button J and then button B and hold down for about 5 seconds, until the yellow led G lights up. To unlock the control panel, press the same buttons again until the yellow led G switches off. 5019 603 33004 D GB F NL E P I GR S N DK FIN [. . . ]