User manual WHIRLPOOL GLS3665RS INSTALLATION

[. . . ] Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] 1 - latest edition or CAN/CGA B149 - latest edition. IMPORTANT: Leak testing of the range must be conducted according to the manufacturer's instructions. Natural Gas: This cooktop is listed by Underwriters Laboratories (UL/cUL) for use with Natural gas or, after proper conversion, for use with LP gas. This cooktop is factory-set for use with Natural gas. to convert to LP gas , see the Gas Conversion instructions provided in the literature package. The model/serial rating plate located on the underside of the burner box has information on the types of gas that can be used. If the types of gas listed do not include the type of gas available, check with the local gas supplier. LP Gas conversion: Conversion must be done by a qualified service technician. No attempt shall be made to convert the appliance from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary. check that the outlet provides 120-volt power and is correctly grounded. The wiring diagram are provided with this cooktop. A smaller size pipe on longer runs may result in insufficient gas supply. With LP gas, piping or tubing size can be ½" minimum. Usually, LP gas suppliers determine the size and materials used in the system. The gas pressure regulator supplied with this cooktop must be used. The inlet pressure to the regulator should be as follows for proper operation: Natural Gas: Minimum pressure: 6" (15. 5 cm) WCP Contact local gas supplier if you are not sure about the inlet pressure. 3 cm) male pipe thread is needed for connection to the female pipe threads of the inlet to the appliance pressure regulator. Do not kink or damage the flexible metal tubing when moving the cooktop. The rigid pipe must be level with the cooktop connection. All strains must be removed from the supply and fuel lines so cooktop will be level and in line. [. . . ] Install the pressure regulator with the arrow pointing up toward the bottom of the burner box and in a position where you can reach the regulator. Center the cooktop in the opening and, using a wood block between the screw and the countertop, moderately tighten the screws to secure cooktop. IMPORTANT: Do not tighten screws directly against the countertop. Up arrow - Regulator must be installed with arrow pointing up at cooktop bottom. [. . . ]