User manual WHIRLPOOL GLS3675VS INSTALLATION 4-10

[. . . ] Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] IMPORTANT: Leak testing of the cooktop must be conducted according to the manufacturer's instructions. Natural Gas: This cooktop is design-certified by CSA International for use with Natural gas or, after proper conversion, for use with LP gas. This cooktop is factory set for use with Natural gas. If the types of gas listed do not include the type of gas available, check with the local gas supplier. LP Gas Conversion: Conversion must be done by a qualified service technician. No attempt shall be made to convert the cooktop from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary. check that the outlet provides 120-volt power and is correctly grounded. The wiring diagrams are provided with this cooktop. The gas pressure regulator supplied with this cooktop must be used. The inlet pressure to the regulator should be as follows for proper operation: Natural Gas: Minimum pressure: 5" (12. 5 cm) WCP Contact local gas supplier if you are not sure about the inlet pressure. A smaller size pipe on longer runs may result in insufficient gas supply. With LP gas, piping or tubing size should be ½" minimum. Usually, LP gas suppliers determine the size and materials used in the system. A ½" male pipe thread is needed for connection to the female pipe threads of the inlet to the cooktop pressure regulator. Do not kink or damage the flexible metal tubing when moving the cooktop. The rigid pipe must be level with the cooktop connection. All strains must be removed from the supply and fuel lines so cooktop will be level and in line. 6 m), ratings are reduced at a rate of 4% for each 1, 000 ft (304. 8 m) above sea level (not applicable for Canada). 5 m) a high altitude kit is needed to avoid any reduced power output. [. . . ] Remove the attachment screws for the selected bracket locations from the bottom of the cooktop base. Select bracket mounting holes that will allow the bracket to extend far enough out from the cooktop for the installation of 2½" (6. Use a new CSA International approved gas supply line. If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column. [. . . ]