User manual WHIRLPOOL GMI 61102 IN INSTRUCTION FOR USE

[. . . ] Antibacterial rinse (Sani Rinse option) This function adds an antibacterial rinse at the end of the wash cycle, guaranteeing a further reduction of bacteria. The indicator light illuminates when the function is activated. If the temperature is not maintained at a constant level during the antibacterial rinse programme (e. If the door is opened or there is a power cut), the programme indicator lights will flash to signal that the sanitizing effect of the antibacterial rinse is not guaranteed. [. . . ] Switch on the dishwasher Press the On/Offbutton. Large compartment A How to fill the detergent dispenser Small compartment B C A B C. Check the rinse aid level Mechanical indicator control panel (if provided). Press the button until the desired programme lights up. D Check the salt level Load the racks Select a programme Select the required options Turn on the tap water tap, then press the start button to start the programme If necessary (where present). The corresponding indicator light illuminates/the display shows the relevant information. €œCancel” Press and keep pressed P until an acoustic signal confirm your selection (the indicator lamp stops flashing and remains lit). Press again and keep pressed until the «end» indicator lamps light up. All water in the tank will be drained and the programme will be stopped immediately. €œChange programme in progress” Press and keep pressed P until an acoustic signal confirm your selection (the indicator lamp stops flashing and remains lit). Wash cycle Switch off the appliance - Only open the door if necessary (Warning: steam may escape). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from the point where it was interrupted. At the end of the programme the dishwasher emits a brief audible signal. Indicator lights 4 + 5 (marked by “end” on the control panel) illuminate. T urn off the the water tap, unload the Warning: be careful openingfrom door, as steam will escape!Empty the dishwasher starting the bottom rack. Dishes from the racks D GB GB LOADING THE DISHWASHER RACKS Upper rack: Cup support rack (A): Depending on the position, raised or lowered. Place glasses in the middle and to the right, dishes to the left, under the cup support rack. Place long and narrow utensils (carving forks, knives) on the bottom of the rack, not crosswise, with the sharp ends pointing inwards towards the appliance. Depending on the model A B A B Rack release lever Rack height adjustment: Release the catches (B) of both rack rails. Reposition the rack at the desired height. aB Lower rack: With tilting plate holders. [. . . ] If dishes are not perfectly dry • Insufficient rinse aid. • Residual water in cavities. If dishes are not perfectly clean • The water spray does not reach the dishes. D GB GB Deposits on dishes • can be removed • Streaks on the dishes/glasses. [. . . ]