User manual WHIRLPOOL GMX 5997 INSTRUCTION FOR USE

[. . . ] 49694610GB. fm Page 12 Wednesday, November 3, 2004 12:14 PM INSTRUCTIONS FOR USE BEFORE USING THE DISHWASHER/ CONNECTIONS ELECTRICAL CONNECTION PRECAUTIONS AND GENERAL RECOMMENDATIONS HOW TO FILL THE SALT CONTAINER HOW TO FILL THE RINSE AID DISPENSER HOW TO FILL THE DETERGENT DISPENSER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE 12 Black process 45. 0° 150. 0 LPI 49694610GB. fm Page 13 Wednesday, November 3, 2004 12:14 PM BEFORE USING THE DISHWASHER/ CONNECTIONS 1. Removing the packaging and controls: After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. • Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous. [. . . ] • Sharp knives and forks that might cause injury must be placed in the cutlery basket with the sharp end facing downwards. Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. • Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap. • If a fault occurs, switch off the appliance and turn off the water tap. • On completion of the programme switch off the dishwasher and turn off the water tap. • Repairs and technical modifications must be carried out exclusively by a qualified technician. • The water in the dishwasher is not potable. • Do not store inflammable liquids near the dishwasher. • Do not operate the appliance in the open air. Resistance to frost: If the appliance is placed in surroundings exposed to the risk of frost, it must be drained completely. Turn off the water tap, remove the flexible inlet and outlet hoses, and let all the water run out. For appliances with water stop system: The water inlet hose and plastic casing contain electrical components. Do not therefore cut the hose or immerse the plastic casing in water. If the hose is damaged switch off the appliance immediately. The appliance must be used at temperatures between 5°C and 45°C. EC Declaration of conformity: This appliance has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: • 73/23/EC • 89/336/EC • 93/68/EC Load capacity: 12 place settings. 15 Black process 45. 0° 150. 0 LPI 49694610GB. fm Page 16 Wednesday, November 3, 2004 12:14 PM HOW TO FILL THE SALT CONTAINER From a water hardness category of 1–2 (medium), before using the dishwasher, fill the salt container with regeneration salt (to find out the hardness level of water in your area, contact your local Water Board or check the last bill you received). The dishwasher is equipped with an electronic control system that allows you to adjust the water softening system to suit the local water hardness level. Adjust the water softening system as follows: If the water hardness level does not correspond to position h3 on the selector (setting on delivery) or if the water hardness level changes: • Press the PROGRAMME DELAY button for a few seconds until the 3 DIGIT DISPLAY shows the set value followed by a dot (3. ). • Once the display shows the desired value, release the button; after 5 seconds the setting automatically returns to programme delay and water hardness level is set to the selected value. • To exit the programming mode press the SET PAUSE button or simply wait approx. Programming must be carried out with the door open; it cannot be carried out with the selector set to the “soak” cycle. NOTE: the display shows water hardness setting and the programme delay. A dot (. ) after the number indicates that the number on the display refers to water hardness level. [. . . ] Slacken the fixing nut (A) (by turning it counter-clockwise) and detach the spray arm (B) by pulling it down. To remount the spray arm, align it and then tighten the fixing nut (by turning it clockwise), paying attention not to bend it. The fixing nut must be tightened until it clicks!Make sure the spray arm rotates freely. A B Lower spray arm: 1. [. . . ]