User manual WHIRLPOOL GS2KVAXVS

[. . . ] If you should experience a problem not covered in TROUBLESHOOTING, please visit our website at www. If you still need assistance, call us at 1-800-253-1301. You will need your model and serial number, located on the inside wall of the refrigerator compartment. Your safety and the safety of others are very important. [. . . ] The ice maker sensors will automatically stop ice production, but the control will remain in the ON (left) position. REMEMBER: Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. Hold the base of the storage bin with both hands and press the release button to lift the storage bin up and out. NOTE: It is not necessary to turn the ice maker control to the OFF (right) position when removing the storage bin. The sensor cover ("flipper door") on the left wall of the freezer stops the ice maker from producing ice if the door is open or the storage bin is removed. Replace the storage bin on the door and push down to make sure it is securely in place. The quality of your ice will be only as good as the quality of the water supplied to your ice maker. avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained. Do not use anything sharp to break up the ice in the storage bin. This can cause damage to the ice container and the dispenser mechanism. Do not store anything on top of or in the ice maker or storage bin. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Press the eject button to release the filter from the base grille. Turn the cap counterclockwise to remove it from the filter. Keep the cap to use with the replacement filter. Align the ridge on the cap with the arrow on the new filter and turn the cap until it snaps into place. NOTE: You can run the dispenser without a filter. Simply insert the cap all of the way into the base grille and rotate the cap until it is firmly in place. Be sure the O-rings are still in place after the covers are removed. [. . . ] Proof of original purchase date is required to obtain service under this limited warranty. iTEMS EXCLUDED FROM WARRANTY This limited warranty does not cover: 1. Replacement parts or repair labor if this major appliance is used for other than normal, single-family household use or when it is used in a manner that is inconsistent to published user or operator instructions and/or installation instructions. Service calls to correct the installation of your major appliance, to instruct you on how to use your major appliance, to replace or repair house fuses, or to correct house wiring or plumbing. [. . . ]