User manual WHIRLPOOL GSC25C6EYB WARRANTY INFORMATION

[. . . ] Oven support surface must be solid, level and flush with bottom of cabinet cutout. Floor must be able to support a total weight (microwave and built-in oven) of 238 lbs (108 kg). IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. This oven has been designed in accordance with the requirements of UL and CSA International and complies with the maximum allowable wood cabinet temperatures of 194°F (90°C) If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and wire gauge are in accordance with local codes. [. . . ] Oven must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located at the bottom of the right-hand mounting rail. Connect directly to the circuit breaker box (or fused disconnect) through flexible, armored or nonmetallic sheathed, copper cable (with grounding wire). see "Make Electrical Connection" section. Flexible conduit from the oven should be connected directly to the junction box. If the house has aluminum wiring follow the procedure below: 1. Aluminum/copper connection must conform with local codes and industry accepted wiring practices. Locate existing wiring to avoid drilling into or severing wiring during installation. Grasp the edges of the oven door with both hands and close the oven door until it will no longer close. Lift and pull oven door toward you and remove. Excessive Weight Hazard Use two or more people to move and install oven. Untwist white wire from green (or bare) ground wire coming from the oven. Connect the 2 white wires (F) together using a UL listed wire connector. Push against seal area of front frame to push oven completely into cabinet and center oven into cabinet cutout. On models with shipping feet, use a Phillips screwdriver to remove screws attaching the shipping feet. Push oven completely into cabinet and center oven into cabinet cutout. Securely fasten oven to cabinet using the # 8­14 x 1" screws (2 for single oven, 4 for double oven) provided. Use the 8-18 x ³/" screws, located in the screw bag assembly, to attach each trim piece to oven. Replace oven door by inserting ends of hinges into hinge slots in the oven frame. Push hinges in as far as they will go and open the oven door. You should feel the oven door drop into place. Rotate both hinge latches back to the locked position. [. . . ] For oven use and cleaning, read the Use and Care Guide. With one # 8­18 x ³/" screw (C) for each side of the vent, fasten vent securely to the oven. Make sure the oven door is closed and the "ON" light is showing in the display area. Slide top end of each trim upward onto oven side rails. [. . . ]