User manual WHIRLPOOL GSF 180 POWER WS PROGRAM CHART

[. . . ] Quick reference guide Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE INSTALLATION INSTRUCTIONS! Options and display description FAULT INDICATION AND WASH TIME DISPLAY In normal operation it indicates the remaining time (h:mm), whereas with “Delayed start” selected it indicates the time remaining until programme start (hh) and below 1h (0:mm). If “F. . ” appears on the display, see chapter “What to do if. . . ”. ON/OFF BUTTON PROGRAMME SELECTION BUTTON Press button “Program” (repeatedly) until the required indicator of programme lights up (see “Table of programmes” below). RESET BUTTON For programme change or indication of faults. this button to cancel a started programme and selected extra options. Press this button to cancel the main fault indicators “F. . ” also refer to the chapter “What to do if. . . ”. [. . . ] Arrange crockery so that items do not touch each other. bowls, cups) must be arranged facing downwards in the rack. If necessary, use more detergent, observing the manufacturer’s indications as regards dosage. Always store detergent in a dry place and do not store it for excessively long periods of time. For heavily soiled crockery, select a wash programme with a higher temperature (see table in chapter “Chart” on page 1). If you select the “Half load/Multizone” function (if available), remember to load only the upper rack or only the lower rack to increase washing power and thus obtain optimum wash results. In the event of frequent use of the Eco 50°C programme (if available), from time to time select the Intensive 70°C programme (if available). The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see chapters 9 and 10). The spray arms must be able to turn freely and must not be impeded by crockery or cutlery. Too little detergent; detergent too old or incorrectly stored. Temperature not high enough for heavily soiled crockery. - Loading of the dishwasher using lower and upper rack at the same time with “Half load/Multizone” function. Clogged spray arms; filters dirty or not fitted correctly. Spray arms impeded by crockery or cutlery. - GB -6- What to do if. . . Crockery and cutlery. . . . . . salt indicator lit . . . have deposits: regeneration salt residue Possible causes. . . Clean dishes left in dishwasher for a long time after end of cycle (e. g. when using “delayed start” function). Incorrect arrangement of the concave items in the rack. Set “Detergent type” option; if this option is not available, it is normal for the salt indicator to light up. In areas with very hard water, more regeneration salt needs to be added (see page 2 “How to set water hardness”). If you use a combined action detergent, try adding more rinse aid. Synthetic materials do not dry well; if wet at end of cycle, wipe dry. [. . . ] We reserve the right to make technical modifications. The guarantee is not applicable if faults are caused by incorrect use of the appliance. - Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap; also after programme end in the event of any malfunction. - Repairs and technical modifications must be carried out exclusively by a qualified technician. [. . . ]