User manual WHIRLPOOL GSF 5300 WH PRODUCT FICHE

[. . . ] The corresponding indicator lamp lights up. “Change programme in progress” Select additional options Press the Start button The selected programme is then memorised (even in the event of power failure). Press the START button for 2 sec. until the Start indicator lamp switches off. Select another programme and press the START button again. Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). [. . . ] Only after the START button has switched off: Press the ON / OFF button. Warning: When the door is opened steam comes out!Unload the appliance, starting from the lower rack. Switch off the appliance Turn off the water tap, unload the racks Dishwasher loading instructions and racks provided depending on the model Upper rack: Crockery holder (A): Depending on the position, for long-handles utensils, cups and plates. carving forks, knives) must be arranged with the sharp end facing in towards the appliance. Half Load: Load the upper rack (see description of Options). Place the cutlery basket (C), if provided, in the upper rack. Rack height adjustment (also when loaded): Pull the two rack handles (D) Lower adjustment: outwards and lower the rack. Pull the two rack handles (D) upwards until the rack clicks Upper adjustment: into place (factory setting). The rack must be level on both sides. B A C D D Retainer open Retainer closed Removing the top rack to provide clearance for large items of crockery in the bottom rack: Open the rack guide retainers (E) on the right and left and remove the top rack. When the upper rack is in place the retainers must always be closed. E E Lower rack: Depending on the model with fixed, tilting (F) or tilting split plate holders (G). Half Load: Load the lower rack (see description of Options). • The START indicator lamp flashes. (if provided). • Use suitable glasses. • Use suitable cutlery. • Ensure the filter assembly is not clogged and that there is no interruption to the water supply (if necessary, clean the filters *). Press the START button for 2 seconds, until the START indicator lamp switches off. Select a new programme and press the Start button again. If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). Before contacting our After-Sales Service, take note of the following: • The nature of the fault • The appliance type and model • The service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side. Before using the dishwasher, read the user instructions! GSF 100 Power Quick Reference Guide GB Wash cycle Programme selection button Pre-Rinse Washing Drying On / Off button Options 3) Power Clean 6) A increased pressure combined with additional spray level offers better cleaning result and more flexibility of dish loading in the lower rack. Start button Switches “on” when the dishwasher is operating. Switches off at the end of the programme. Time and failure display Indicators Add rinse aid Add regeneration salt Only add regeneration salt immediately before starting a wash programme. Indicates in hours the time remaining until the start of the wash cycle. Switches off at programme start and indicates the remaining time in hours and minutes. “F. . . . ” Information for the After-Sales Service “Delayed start” button The wash cycle can be programmed to start after 1 - 24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00. The dishwasher will start at the set time. Detergent light No light = detergent in powder or The symbol lights up = tablets 2 in 1 or The symbol lights up = tablets 3 in 1. . . . [. . . ] X in 1 (For adjustment refer to “How to use the appliance”) “Half load - Multizone” button Load the upper or lower rack only. This function can be used with any programme. Press once = upper rack (the indication lamp/symbol comes on) Press twice = lower rack (the indication lamp/symbol comes on) Press 3 times = Off (half load function deactivated). When washing without the top rack, press the “Half Load” button twice, or “Lower rack wash” (the corresponding LED/symbol comes on). Programme chart Programmes Loading instructions Lightly, normally or heavily soiled Steam Sensor + 6) 40-70°C crockery, including pots and pans. Detergent 2) Consumption 3) Litres kWh Minutes A X X X X X X B X X X X 7-17 0. 99-1. 75 65-220 4. 0 10. 0 10. 0 11. 0 13. 0 13. 0 0. 03 0. 85 0. 65 1. 05 1. 50 1. 20 14 125 30 140 115 290 Pre-Rinse Hand washing Rapid Bio Normal 1) 6) Hygiene + 4) 5) 6) Overnight 1) 2) 3) cold 40°C 40°C 50°C Crockery to be washed later. [. . . ]