User manual WHIRLPOOL GSF 7293 TW-WS PROGRAM CHART

[. . . ] Press the On/Off button to switch the dishwasher on. One of the programme indicator lamps will switch on. Select the desired programme by pressing the corresponding button. The corresponding indicator lamp lights up. [. . . ] • May be used in three different positions (see also “Dishwasher loading instructions” on Page 4). 1. Upside-down, towards the centre of the rack. Upside-down, towards the left side. C Cutlery basket (C): • with or without handle (depending on model). • The cutlery basket can be removed to increase available space C Rack height adjustment: (The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded. Glass holder: Please read the user instructions carefully. Troubleshooting Guide Tips and advice • Arrange crockery so that items do not touch each other. Arrange large crockery in the lower rack and smaller crockery in the upper rack. Load cups at an angle to facilitate water drainage. Generally speaking, place cutlery in the basket with the handles positioned downwards, but ensure that any sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. Make sure the water jet can reach all loaded items and that the spray arms turn freely. • Only switch off the dishwasher once the “Start” indicator lamp has switched off. If the dishwasher is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted without having to start it again. Crockery still dirty after washing: • Was the crockery loaded properly?• Crockery must be loaded facing downwards; this is important, especially for large items of crockery. • The water jets must spray the entire surface of all items. • Make sure that crockery and cutlery are arranged properly. • Have you selected the correct programme?• Did you use too much or too little detergent?(The use of poor quality detergents results in less effective washing). • Are the filters clogged or incorrectly assembled?(See “Care and Maintenance” chapter in the user instructions). • Are the spray arms blocked or the nozzles clogged?(See “Care and Maintenance” chapter in the user instructions). [. . . ] Before starting a wash programme, make sure that the spray arms can turn freely and are not blocked by crockery or cutlery. • • • • • If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket?• Has the Start button been pressed?• Has the delayed start timer been set (if fitted)?• Is the flow of water obstructed by impurities? [. . . ]