User manual WHIRLPOOL GSF 7396 TW-WS PROGRAM CHART

[. . . ] Switches off when the programme has started. Toward the end of the programme, during the drying cycle, the display will indicate the time remaining in minutes. “F1-F9” Identification of faults for service technician. Start button Salt level indicator Indicator lamp lit while the dishwasher is operating. Switches off at the end of the programme. On / Off Button Place the detergent in the: small compartment large compartment Consumption 1) Normal load / (Half load) Water (Litres) (13. 5) Energy (kWh) (1. 3) Time (Min. ) (80) Programme Symbol and Temperature Programme selection and recommended load type Recommended programme for routine washes, for Eco Normal 40 - 55° C crockery with little or no dried-on food. [. . . ] The rack must be level on both sides. Lower rack B A Crockery Holders: Down: cups and long-stemmed glasses. Up: plates. Upper rack C Half Load: Loading the lower rack only gives greater washing power, especially for plates and saucepans. Plate holders: • • May be lowered to increase available space (A). May be removed to increase available space(B). To remove: pull the handle up. "Vario Organizer” multi-purpose support: • To be used, for example, for longhandled utensils (arrange knives with the blade facing downwards), cups and glasses. May be used in three different positions (see also “Dishwasher loading instructions” on Page 4). Upside-down, towards the centre of the rack. Upside-down, towards the left side. Half Load: If only the upper rack is to be loaded remove the cutlery basket from the lower rack and place it in the upper one. • 1. 3. B A Cutlery basket: The cutlery basket can be removed to increase (C) available space. Rack height adjustment: (The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded. • To lower: pull out the two side handles and gently lower the rack. Glass holder: C Please read the user instructions carefully. Troubleshooting Guide Tips and advice • Arrange crockery so that items do not touch each other. Arrange large crockery in the lower rack and smaller crockery in the upper rack. Load cups at an angle to facilitate water drainage. Generally speaking, place cutlery in the basket with the handles positioned downwards, but ensure that any sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. Make sure the water jet can reach all loaded items and that the spray arms turn freely. • Before starting a wash programme, make sure that the spray arms can turn freely and are not impeded by crockery or cutlery. Only switch off the dishwasher once the “Start” indicator lamp has switched off. If the dishwasher is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted without having to start it again. Select a new programme and press the Start button. Crockery still dirty after washing: • Was the crockery loaded properly?• Crockery must be loaded facing downwards; this is important, especially for large items of crockery. • The water jets must spray the entire surface of all items. [. . . ] If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). Sometimes even though the regeneration salt container has been filled, the corresponding indicator lamp (if fitted) will light up during the first wash cycle after filling with salt. • • • • If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket?• Has the Start button been pressed?• Has the delayed start timer been set (if fitted)? [. . . ]