User manual WHIRLPOOL GSI 4743/5 CTW-SW PROGRAM CHART

[. . . ] The dishwasher switches on automatically as soon as the programme selector knob is turned. One of the programme indicator lamps will illuminate. Turn the selector knob to select the desired programme. The corresponding indicator lamp lights up. [. . . ] Upside-down, towards the left side. • May be lowered to increase available space (A). May be removed to increase available space(B). To remove: pull the handle upwards. B A . • 1. 3. Cutlery basket: The cutlery basket (C) may be removed to increase available space. C Rack height adjustment: (The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded. Glass holder: Please read the user instructions carefully. Troubleshooting Guide Tips and advice • Arrange crockery so that items do not touch each other. Arrange large crockery in the lower rack and smaller crockery in the upper rack. Load cups at an angle to facilitate water drainage. Generally speaking, place cutlery in the basket with the handles positioned downwards, but ensure that any sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. Make sure the water jet can reach all loaded items and that the spray arms turn freely. • Before starting a wash programme, make sure that the spray arms can turn freely and are not blocked by crockery or cutlery. Switch off the dishwasher once the “Start” indicator lamp has switched off. If you switch off the dishwasher during a wash cycle, when switched on again the dishwasher resumes the cycle from where it was interrupted without having to start it again. Crockery still dirty after washing: • Was the crockery loaded properly?• Crockery must be loaded facing downwards; make sure, especially for large crockery. • The water jets must spray the entire surface of all items. • Make sure that crockery and cutlery are arranged properly. • Have you selected the correct programme?• Did you use too much or too little detergent?(The use of poor quality detergents result in less effective washing). • Are the filters clogged or incorrectly assembled?(See “Care and Maintenance” chapter in the user instructions). • Are the spray arms blocked or the nozzles clogged? [. . . ] If a regeneration salt is to be added, IMMEDIATELY start a wash programme, in order to eliminate any residual salt (rinsing alone is not sufficient). • • • • If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket?• Has the Start button been pressed?• Has the delayed start timer been set (if fitted)?• Is the flow of water obstructed by impurities? [. . . ]