User manual WHIRLPOOL GSI 4753/3 TW-SW PROGRAM CHART

[. . . ] Programme recommended when using detergents of type A (non enzyme-based detergents). 5019 100 90271 (We reserve the right to make technical modifications) How to use the dishwasher 1. After loading the dishwasher, close the door properly and open the water supply tap. Press the On/Off button to switch the dishwasher on. One of the programme indicator lamps will switch on. [. . . ] Upside-down, towards the left side. Plate holders: • • May be lowered to increase available space (A). May be removed to increase available space (B). To remove: pull the handle up. B A Cutlery basket: The cutlery basket can be removed to increase (C) available space. Rack height adjustment: (The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded. • To lower: pull out the two side handles and gently lower the rack. • To raise: pull up the two side handles until the rack clicks into place. • The rack must be level on both sides. C Glass holder: Please read the user instructions carefully. Troubleshooting Guide Tips and advice • Arrange crockery so that items do not touch each other. Arrange large crockery in the lower rack and smaller crockery in the upper rack. Load cups at an angle to facilitate water drainage. Generally speaking, place cutlery in the basket with the handles positioned downwards, but ensure that any sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. Make sure the water jet can reach all loaded items and that the spray arms turn freely. • Before starting a wash programme, make sure that the spray arms can turn freely and are not impeded by crockery or cutlery. Only switch off the dishwasher once the “Start” indicator lamp has switched off. If the dishwasher is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted without having to start it again. Crockery still dirty after washing: • Was the crockery loaded properly?• Crockery must be loaded facing downwards; this is important, especially for large items of crockery. • The water jets must spray the entire surface of all items. • Make sure that crockery and cutlery are arranged properly. • Have you selected the correct programme?• Did you use too much or too little detergent?(The use of poor quality detergents may result in less effective washing). • Are the filters clogged or incorrectly assembled? [. . . ] Sometimes, even though the regeneration salt container has been filled, the corresponding indicator lamp (if fitted) will light up during the first wash cycle after filling with salt. • • • • If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket?• Has the Start button been pressed?• Has the delayed start timer been set (if fitted)?• Is the flow of water obstructed by impurities? [. . . ]