User manual WHIRLPOOL GSI 4794 ETW-IN PROGRAM CHART

[. . . ] Switches off at the end of the programme Programme Symbol and Temperature Programme selection and recommended load type Consumption 1) Normal load / (Half load) Water (Litres) (13. 5) Energy (kWh) (1. 3) Time (Min. ) (80) Eco Normal 40 - 55° C Recommended programme for routine washes, for crockery with little or no dried-on food. X X (11. 5) (19. 5) (0. 9) (1. 7) (60) (98) Intensive 60 - 70° C Recommended programme for heavily soiled crockery, with dried-on food. Especially suitable for pans and saucepans. Lightly soiled crockery with no dried-on food. Light soiling, especially glasses and cups. X X (11. 5) (1. 3) 0. 02 (0. 02) 0. 85 (0. 75) 0. 82 (0. 78) 1. 03 (0. 90) 9 30 60 (90) (9) (30) (59) Pre-wash Rapid 40° C Glasses 40° C Bio-Normal 50° C 1) 2) 2) X X X X 5. 0 13. 0 12. 5 16. 0 (4. 2) (13. 0) (10. 5) (14. 5) Normally or heavily soiled crockery with dried-on food. 120 (117) Values may vary in relation to usage, e. g. : different loads, water temperatures - above or below 15° C - as well as water hardness and power supply voltage etc. [. . . ] To raise: pull up the two side handles until the rack clicks into place. Up: plates. Lower rack A A Crockery holders: Upper rack B “Vario Organizer” multi-purpose support: To be used, for example, for long-handled utensils (arrange knives with the blade facing downwards), cups and glasses. • May be used in three different positions (see also “Dishwasher loading instructions” on Page 4). Upside-down, towards the centre of the rack. • C Half Load: Loading the lower rack only gives greater washing power, especially for plates and saucepans. Plate holders: • May be lowered to increase available space (A). Half Load: If the upper rack only is to be loaded, place the cutlery basket “B” in the upper rack. A Cutlery basket: • • The cutlery basket can be removed to increase (B + C) available space. Some models are provided with a grid (D) that can be fitted onto the cutlery basket. Rack height adjustment: (The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded. Glass holder: B D C Please read the user instructions carefully. Troubleshooting Guide Tips and advice • Arrange crockery so that items do not touch each other. Arrange large crockery in the lower rack and smaller crockery in the upper rack. Load cups at an angle to facilitate water drainage. Generally speaking, place cutlery in the basket with the handles positioned downwards, but ensure that any sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. Make sure the water jet can reach all loaded items and that the spray arms turn freely. • Before starting a wash programme, make sure that the spray arms can turn freely and are not impeded by crockery or cutlery. Switch off the dishwasher once the “Start” indicator lamp has switched off. If you switch off the dishwasher during a wash cycle, when switched on again the dishwasher resumes the cycle from where it was interrupted without having to start it again. Crockery still dirty after washing: • Was the crockery loaded properly?• Crockery must be loaded facing downwards; this is important, especially for large items of crockery. • The water jets must spray the entire surface of all items. • Make sure that crockery and cutlery are arranged properly. • Have you selected the correct programme?• Did you use too much or too little detergent?(The use of poor quality detergents may result in less effective washing). • Are the filters clogged or incorrectly assembled? [. . . ] Sometimes even though the regeneration salt container has been filled, the corresponding indicator lamp (if fitted) will light up during the first wash cycle after filling with salt. • • • • If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket?• Has the Start button been pressed?• Has the delayed start timer been set (if fitted)?• Is the flow of water obstructed by impurities? [. . . ]