User manual WHIRLPOOL GSI 4875/3 TW-IN PROGRAM CHART

[. . . ] GB GSI 4875 / GSF 5476 PROGRAMME CHART Water supply tap indicator Turn on the tap. Programme progress indicator Pre-rinse Only lights up for programmes with prewash (the symbol “+” in the table below indicates that detergent must be added). Time and Failure display Indicates the time remaining until the start of the washing cycle, in hours. Toward the end of the programme, the display will indicate the time remaining in minutes. [. . . ] Heavily soiled pans and saucepans. Intensive 70° C *) 1) 2) Values for normal conditions. Values may vary in relation to usage, e. g. : different loads, water temperatures, water hardness and power supply voltage. Programme recommended when using detergents of type A (non enzyme-based detergents). Programme recommended when using detergents of type B (enzyme-based detergents). Check the programme on the energy data plate. 5019 100 90114 (We reserve the right to make technical modifications) Quick Reference Guide Daily check list 1. Arrange crockery so that items do not touch each other. Load cups at an inclination to facilitate water circulation. In general, place cutlery in the basket with the handles positioned downwards, but ensure that any sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. Make sure the water jet can reach all loaded items and that the spray arms turn freely. Turn on the water supply tap before starting the dishwasher. GB Lower rack Upper rack Crockery Holders: • Lowered: cups and longstemmed glasses. • Raised: plates. Cutlery holder for long utensils: • Raised: glass holder (gently lift up and release). • Lowered: large cutlery (gently lift up). • Place knives with blades facing downwards. Important: • Switch off the dishwasher: once the “Start” indicator lamp has switched off. If the dishwasher is turned off during the washing programme, it will start again from the same point in the programme when it is turned back on. If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off! [. . . ] • To remove: pull the handle upwards. • To reposition: simply insert in the required position (normal or crosswise). Also refer to the “Dishwasher Loading Instructions” which contain detailed information and useful tips. [. . . ]