User manual WHIRLPOOL GSI 4875 CTW-IN PROGRAM CHART

[. . . ] GB GSI 4875 PROGRAMME CHART Rinse aid level indicator Add rinse aid. Load the upper or lower rack only. This function can be used with any programme. Half Load button Salt level indicator Add regeneration salt. Time and Failure Display Switches on when the dishwasher is operating. Switches off at the end of the programme. Start button indicator lamp Programme progress indicator Pre-rinse Only lights up for programmes with prewash (the symbol “+” in the table below indicates that detergent must be added). Rinsing / Washing Drying End Programme Indicates the time remaining at the start of the washing cycle, in hours. [. . . ] Heavily soiled pans and saucepans. Values for normal conditions. Values may vary in relation to usage, e. g. : different loads, water temperatures, water hardness and power supply voltage. 1) Programme recommended when using detergents of type A (non enzyme-based detergents). 2) Programme recommended when using detergents of type B (enzyme-based detergents). Check the programme on the energy label. 5019 100 90510 (We reserve the right to make technical modifications) Quick Reference Guide Daily check list 1. Arrange crockery so that items do not touch each other. Load cups at an inclination to facilitate water circulation. In general, place cutlery in the basket with the handles positioned downwards, but ensure that any sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. Make sure the water jet can reach all loaded items and that the spray arms turn freely. Turn on the water supply tap before starting the dishwasher. GB Lower rack Upper rack Crockery holders: • Down: cups and long-stemmed glasses. • Up: plates. Cutlery holder for long utensils: • Up: glass holder (gently lift up and release). • Down: large cutlery (gently lift up). • Place knives with blades facing downwards. Important: • Switch off the dishwasher: once the “Start” indicator lamp has switched off. If you switch off the dishwasher during a wash cycle, when switched on again the dishwasher resumes the cycle from where it was interrupted. If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off! [. . . ] • The rack must be level on both sides. Plate holders: • The plate holders may be removed to increase available space. • To remove: pull the handle upwards. • To reposition: simply insert in the required position (normal or crosswise). [. . . ]