User manual WHIRLPOOL GSI 4875 TW- INSTRUCTION FOR USE

[. . . ] 94000-gb. fm5 Page 12 Thursday, September 13, 2001 4:13 PM GB SUMMARY PAGE BEFORE USING THE DISHWASHER PROTECTING THE ENVIRONMENT PRECAUTIONS AND GENERAL RECOMMENDATIONS ENERGY AND WATER SAVING TIPS HOW TO FILL THE SALT CONTAINER HOW TO FILL THE RINSE AID DISPENSER HOW TO FILL THE DETERGENT DISPENSER HOW TO USE THE DISHWASHER CONNECTIONS MAINTENANCE AND CLEANING TROUBLESHOOTING GUIDE AFTER-SALES SERVICE 13 13 13 13 14 15 16 17 18 20 21 21 PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE For maximum satisfaction from your dishwasher, carefully read these user instructions and consult the wash programme chart. 12 94000-gb. fm5 Page 13 Thursday, September 13, 2001 4:13 PM BEFORE USING THE DISHWASHER • After unpacking, make sure the appliance is undamaged and that the door closes correctly. Do not use the appliance if it is damaged. If in doubt, consult your local retailer. Keep potentially hazardous packaging (plastic bags etc. ) out of the reach of children. [. . . ] Use a smaller quantity of detergent. Normal load: For programmes with pre-rinse. (Example: Normal 65°C, refer to the “Wash programme chart”). Pour two thirds of the recommended dosage in the large compartment. Pour the remaining third in the small compartment. Note: Remember to close the large compartment lid. Large compartment volume: 45 ml (up to rim). Small compartment volume: 10 ml (up to rim). For programmes without pre-rinse: • Pour the entire recommended dosage in the large compartment. If the recommended dosage on the detergent pack is over 45 ml, pour the remaining detergent in the small compartment. 16 94000-gb. fm5 Page 17 Thursday, September 13, 2001 4:13 PM HOW TO USE THE DISHWASHER Close the dishwasher door and turn on the water tap. 1. Press the ON/OFF button to switch on the dishwasher. One of the programme indicator lamps will illuminate. 1 2. Select the required programme by pressing the programme button. The corresponding indicator lamp will illuminate. If required, select any additional functions. 2 3. Press the Start button to start the selected wash programme. The corresponding indicator lamp will illuminate. Once set, the programmed data cannot be altered by turning the programme selector knob or pressing the buttons. Note: Once the Start button has been pressed, the dishwasher memorises all the programmes selected. The selected programmes are also saved in the event of power failure. To change the programme selected, press the Start button for about 5 seconds until the Start indicator lamp switches off. Select a new programme using the programme button and press the Start. The End indicator lamp (if fitted) illuminates briefly and the Start indicator lamp switches off to indicate the end of the programme. [. . . ] If the malfunction persists, switch off the appliance and turn off the water tap. The appliance will not switch on: • Power plug properly inserted in the mains socket?• Have you switched the dishwasher on?• Have you pressed the Start button? [. . . ]