User manual WHIRLPOOL GSI 5513 SW INSTALLATION

[. . . ] The inlet water temperature varies according to the model installed. Depending on the appliance model, the solenoid valve of the inlet hose will be activated by the mains voltage (see assembly instructions). Make sure the inlet and drain hoses are kink-free and are not crushed. [. . . ] The power cable must only be replaced by a qualified technician. After appliance installation, the mains plug must be easily accessible so that the appliance can be unplugged if necessary at any time. For Austria: If a fault current switch is fitted upline of the appliance, this must be pulse current-sensitive. Assembly instructions During assembly the appliance must be unplugged from the mains. Set any electrical screwdrivers to a low torque. Leave a gap of at least 3 mm between the top edge of the wooden door and the worktop. Do not seal the gaps between adjacent units and the worktop (for example with silicone). Attention: when transporting and assembling the appliance, always wear gloves to protect fingers / hands from sharp edges and corners. If the appliance is installed at the end of a row of units, making the side panel accessible, the hinge area must be covered to prevent any risk of crushing (cover available from After-sales Service ). Be careful with uneven installation surfaces: Carefully push the dishwasher with feet unscrewed under the worktop. After fitting the plinth and decor panel and before opening the door, evaluate whether the plinth needs to be cut and, if so, how much (see assembly instructions) in order to avoid any damage. The sharp edges of the unit and the plinth must be protected from humidity (with insulating material, for example silicone, not included with the appliance). General indications The appliance must only be used in the household and according its purpose. Do not use the dishwasher until it has been fully assembled. Do not use the dishwasher if it has been damaged in transit. contact After-Sales Service or your local dealer. Before carrying out any cleaning or maintenance operations, unplug the appliance and turn off the water tap. The same applies in the event of a malfunction. [. . . ] please do not attempt to change plug yourself. This procedure needs to be carried out by a qualified Whirlpool technician in compliance with the manufactures instructions and current standard safety regulations. Sørg for at slangene for vanntilførsel og vannavløp er uten krøll eller bukter. [. . . ]