User manual WHIRLPOOL GSI 5533 IN PRODUCT FICHE

[. . . ] • • This appliance is designed for use in the home in compliance with its intended purpose. All water and electrical connections must be carried out by a qualified technician in compliance with the manufacturer's instructions (refer to the enclosed installation booklet) and current local safety regulations. • PROTECTING THE ENVIRONMENT 3. Packing The packing box may be fully recycled as confirmed by the recycling symbol . Appliance The appliance is built from reusable materials. [. . . ] If crockery is prone to whitish streaks, reduce the dosage by turning the dial to a lower setting. If instead crockery is wet, increase the dosage by turning the dial to a higher setting. Rinse aid level indicator (visual or electric indicator depending on the model installed). Electric indicator: The indicator lamp on the control panel illuminates when the rinse aid dispenser is empty. Visual indicator: light = empty dark = full. 15 94017-gb. fm5 Page 16 Wednesday, September 26, 2001 6:15 PM HOW TO FILL THE DETERGENT DISPENSER Only use detergents recommended for use in domestic dishwashers. If you use “new generation” enzyme-based detergents, select the Bio programmes which are also suitable for all normal detergents. If you use detergents in pellet form, follow the manufacturer's directions for use. Always use the recommended dosage stated on the detergent pack. The use of detergent in excess of the recommended dosage may cause pollution. The recommended dosage varies between different brands. The figures inside the large compartment serve as a dosage guide. The The figures are in “ml” or “cm3”. Only fill the detergent dispenser prior to starting a wash programme. The End indicator lamp (if fitted) illuminates briefly and the Start indicator lamp switches off to indicate the end of the programme. Press the ON/OFF button to switch off the dishwasher (only after the End indicator lamp has switched on or the Start indicator lamp has switched off). Note: If the dishwasher is switched off during a wash programme, when switched on again the dishwasher resumes the wash cycle from where it was interrupted. Open the door and unload first the lower rack and then the upper one. 3 4 5/6 17 94017-gb. fm5 Page 18 Wednesday, September 26, 2001 6:15 PM CONNECTIONS Refer to the separate installation instructions booklet. Water inlet and drain: • Strictly follow local Water Board regulations. • Make sure the inlet and drain hoses are kinkfree and are not crushed. • If the hose length does not suffice, replace with similar hoses obtained from your local dealer or our After-Sales Service. • The inlet hose must be securely clamped to the water tap to prevent leaks. • The inlet water temperature varies according to the model installed: inlet hose marked “25°C max. ”: maximum temperature 25°C. All other models: maximum temperature 60°C. • When installing the appliance, make sure the drain water discharges correctly and, if necessary, remove the wire gauze from the sink siphon. [. . . ] The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured red. Remove the fuse cover (A) and the fuse (B). Fit the replacement 13 A fuse into the fuse cover. For all other types of plug, the supply socket should be protected by a 16 A fuse or circuit breaker at the distribution board. 19 94017-gb. fm5 Page 20 Wednesday, September 26, 2001 6:15 PM MAINTENANCE AND CLEANING Before cleaning or carrying out maintenance, press the ON/OFF button. [. . . ]