User manual WHIRLPOOL GSI 6988 C-WS PROGRAM CHART

[. . . ] START BUTTON RESET FUNCTION: Press this button for at least 2 seconds; the selected programme and options will be cancelled. Main failure displays (repeated flashing of the START indicator lamp) can be cancelled by RESETTING. Detailed instructions are given in chapter “What to do if. . . ”. START DELAY option MULTI ZONE option ON/OFF BUTTON (see at right for options description) Table of programmes Consumption Detergent Loading instructions Normally or heavily soiled crockery, including pots and pans. Thanks to steam action, soaking or hand pretreatment is no longer needed. [. . . ] . . . Exercise caution when opening the door: beware of hot steam. Only press the OFF button once the START indicator lamp has switched off. Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below. Maintenance and care Maintenance and care Screw on filter cylinder NOTE MARK!Unscrew filter cylinder, remove it and fine sieve. . . Insert Filters Check and clean if necessary Rectifying minor faults yourself . . . 10 Insert and screw on lower and upper arms tightly. Clean spray nozzles under running water (use toothpicks if necessary) . . . Spray arms Remove blockages/ deposits. GB -5- What to do if. . . If a fault occurs, before restoring normal appliance operation contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. . . . is not working/will not start . . . shows “F1” on the display or the START indicator lamp flashes once . . . shows “F4” on the display or the START indicator lamp flashes 4 times . . . shows “F6” on the display or the START indicator lamp flashes 6 times . . . shows “F7” on the display or the START indicator lamp flashes 7 times . . . shows “F8” on the display or the START indicator lamp flashes 8 times Possible causes. . . The water supply temperature is below 3°C. Kinked water inlet hose or clogged inlet filters. Kinked water inlet hose or clogged inlet filters. - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long time after end - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. when using “delayed start” function). releasing the door 5 minutes before removing the dishes. Incorrect arrangement of the concave items in the rack. - Arrange crockery so that water does not collect in cavities. - Increase the dosage of rinse aid - see page 3, chapter “Adding rinse aid”. - The rapid programme is intended for quickly washing lightly soiled dishes. If used for a full load of medium/ heavy soiled dishes, the dishes may not dry completely. If so, select a standard-length programme. [. . . ] - The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it. - Sharp items that might cause injury (e. g. knives), must be placed in the cutlery basket with the sharp end facing downwards. [. . . ]