User manual WHIRLPOOL GSI 7494 CTW-IN PROGRAM CHART

[. . . ] Programme selector Time and failure display Indicates in hours the time remaining until the start of the wash cycle. Switches off when the programme has started. Toward the end of the programme, during the drying cycle, the display will indicate the time remaining in minutes. “F1-F4”, “F7-F9” Identification of faults for service technician. [. . . ] Turn the programme selector knob counter clockwise to the initial position to switch off the dishwasher (only after the Start indicator lamp has switched off). Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. • • • • • Upper and lower rack To lower: pull out the two side handles and gently lower the rack. To raise: pull up the two side handles until the rack clicks into place. Up: plates. Lower rack A A Crockery holders: Upper rack B Half Load: “Vario Organizer” multi-purpose support: To be used, for example, for longhandled utensils (arrange knives with the blade facing downwards), cups and glasses. • May be used in three different positions (see also “Dishwasher loading instructions” on Page 4). Upside-down, towards the centre of the rack. • C Loading the lower rack only gives greater washing power, especially for plates and saucepans. Plate holders: • May be lowered to increase available space (A). Half Load: If the upper rack only is to be loaded, place the cutlery basket “B” in the upper rack. A Cutlery basket: • • The cutlery basket can be removed to increase (B + C) available space. Some models are provided with a grid (D) that can be fitted onto the cutlery basket. Rack height adjustment: (The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded. B Glass holder: D C Please read the user instructions carefully. Troubleshooting Guide Tips and advice • Arrange crockery so that items do not touch each other. Arrange large crockery in the lower rack and smaller crockery in the upper rack. Load cups at an angle to facilitate water drainage. Generally speaking, place cutlery in the basket with the handles positioned downwards, but ensure that any sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. Make sure the water jet can reach all loaded items and that the spray arms turn freely. • Before starting a wash programme, make sure that the spray arms can turn freely and are not impeded by crockery or cutlery. Switch off the dishwasher once the “Start” indicator lamp has switched off. If you switch off the dishwasher during a wash cycle, when switched on again the dishwasher resumes the cycle from where it was interrupted without having to start it again. Crockery still dirty after washing: • Was the crockery loaded properly?• Crockery must be loaded facing downwards; this is important, especially for large items of crockery. • The water jets must spray the entire surface of all items. • Make sure that crockery and cutlery are arranged properly. [. . . ] Sometimes even though the regeneration salt container has been filled, the corresponding indicator lamp (if fitted) will light up during the first wash cycle after filling with salt. • • • • If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket?• Has the Start button been pressed?• Has the delayed start timer been set (if fitted)?• Is the flow of water obstructed by impurities? [. . . ]