User manual WHIRLPOOL GSI PLATINUM 3 PT PRODUCT FICHE

[. . . ] Inlet hose marked “25° C Max”: maximum temperature 25° C. All other models: maximum temperature 60° C. • When installing the appliance, make sure the drain water discharges correctly (if necessary, remove the wire gauze from the sink siphon). • Fix the drain hose to the spigot with a clamp to prevent it from coming off during operation. [. . . ] Make sure the water inlet hose is of the correct type. Refer to the “Connections” chapter in these user instructions. Disposal: The appliance is built from reusable materials. If you decide to scrap the dishwasher, it must be disposed of in compliance with local waste disposal regulations. • Before scrapping, cut off the power cable so that the appliance cannot be connected to the mains. Child safety: • Children must not be allowed to play with the dishwasher. • Store the detergent, rinse aid and salt in a dry place out of the reach of children. General recommendations: • The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it: the appliance may topple over!• Do not use solvents inside the dishwasher: risk of explosion!• Only use detergents, rinse aids and regeneration salts specially recommended for use in domestic dishwashers. Before using the dishwasher for the first time, fill the rinse aid dispenser. Only use rinse aids recommended for use in domestic dishwashers. Press button A to open the cover (see drawing). Fill the dispenser with rinse aid up to the dashed line (about 100 ml. Immediately wipe away any rinse aid spilt accidentally!This prevents the formation of excess suds which may spoil washing results. Thereafter, regularly check the rinse aid level. A How to adjust the rinse aid dosage regulator: Factory setting: Position 4. If you are not satisfied with washing or drying results, change the rinse aid dosage setting. 1. Press button A to open the cover (see drawing). If crockery is prone to whitish streaks: reduce the dosage by turning the dial to a lower setting (1-3) using a coin or the like. If crockery is not perfectly dry: increase the dosage by turning the dial to a higher setting (5-6). [. . . ] The fixing nut must be tightened until it clicks! Make sure the spray arm rotates freely. A B Lower spray arm: 1. Slacken the fixing nut (C) (by turning it counter-clockwise) and detach the spray arm (D) by pulling it upwards. To remount the spray arm, align it and then tighten the fixing nut (by turning it clockwise), paying attention not to bend it. The fixing nut must be tightened until it clicks! Make sure the spray arm rotates freely. D C 17 Care and Maintenance Cleaning the filters: 1. [. . . ]