User manual WHIRLPOOL GSUP 6142 DI IN A PRODUCT FICHE

[. . . ] If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if. . . ”. RINSE AID INDICATOR When lit (at the end of the cycle), the rinse aid dispenser needs to be refilled. SALT INDICATOR When lit (at the end of the cycle), the salt reservoir needs to be refilled. 5019 496 01764 PROGRAM SELECTION BUTTON MULTIZONE Push “P” button (repeatedly) until selected program number is shown on the display (P1. . . Px) see “Table of programs” next page). Allows you to choose the washing zones. Press this button (repeatedly) to select the wash zones: both racks only lower rack only upper rack - indicator lits POWER CLEAN Thanks to the additional power jets this option provides a more intensive and powerful wash in the lower rack, in the specific area. [. . . ] The corresponding programs for your appliance can be found on the panel (page 1). Choose program according to the attached Table of programs (page 2). Duration of the program depends on the external conditions in the apartment, temperature and pressure etc. Wash cycle The dishwasher door must be closed and the water tap open. To pause the program (e. g. if you want to insert an item): - Open the door with caution (the program pauses) and insert the item/s, (beware of HOT steam!). - Close the door and press the START button again to restart the cycle (the program resumes the cycle from where it was interrupted). To Cancel the program on running: - Press the CANCEL/Off button. - (Water drains for up to 1 minute then the appliance switches off). To change the program in progress: - Press the CANCEL/Off button to cancel the program on running. - (Water drains for up to 1 minute then the appliance switches off). - Press any button except CANCEL/Off button to switch on the appliance. - Press the START button. Switching off the appliance. Always store detergent in a dry place and do not store it for excessively long periods of time. - For heavily soiled crockery, select a wash program with a higher temperature (see Table of programs - chapter “Chart” - page 2). - Loading of the dishwasher using lower and - If you select the “Half load/Multizone” option (if available), remember to load only upper rack at the same time with “Half the upper rack or only the lower rack to increase washing power and thus obtain load/Multizone” option. - Clogged spray arms, dirty filters or not fitted correctly. - Spray arms stuck impeded by crockery or cutlery. . . . salt indicator lit . . . have deposits: regeneration salt residue - Use tablets for soft water. . . . are not dry - Plastic containers dry badly. - Clean dishes left in dishwasher for a long time after end of cycle (e. g. when using “Delayed start” option). - Incorrect arrangement of the concave items in the rack. - In the event of frequent use of the Eco 50°C program (if available), from time to time select the Intensive 65°C program (if available). - The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see page 8, “Maintenance and care“). [. . . ] - Be careful when the door is open: risk of tripping!- The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it. - Sharp items that might cause injury (e. g. [. . . ]