User manual WHIRLPOOL GSXA 7525 BK INSTRUCTION FOR USE

[. . . ] If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if. . . ”. SALT INDICATOR When lit (at the end of the cycle), the salt reservoir needs to be refilled. RINSE AID INDICATOR When lit (at the end of the cycle), the rinse aid dispenser needs to be refilled. 5019 496 01729 PROGRAMS SELECTION BUTTON Push “Programs” button (repeatedly) until the indicator of the required program lights up (see “Table of programs” next page). ANTIBACTERIAL RINSE 3) TABLET SETTING This function activates an antibacterial rinse at the end of the wash cycle, guaranteeing a further reduction of bacteria. Press the button to activate or deactivate the function. [. . . ] To change the program in progress: - Open the door, press the CANCEL/Off button to cancel the running program and close the door. - (Water drains for up to 1 minute then the appliance switches off). - Open the door and press any button except CANCEL/Off button to switch on the appliance. - Press the START button and close the door within 3 seconds Switching off the appliance. Everything OK. . . After the program is completed appliance turns into Standby mode automatically. Exercise caution when opening the door: beware of hot steam. Unload the appliance starting from the lower rack in order to avoid any residual drips of water falling onto crockery below. For even better drying results, leave the dishwasher door open a little before unloading in order to allow the steam to dissipate, helping the dishes to dry. The underside of the kitchen worktop must be protected (see instructions in ‘Assembly instructions’). Maintenance and care Maintenance and care Screw on microfilter NOTE MARK!Unscrew microfilter (1), remove it (2) and remove fine sieve (3). . . Insert Filters Check and clean if necessary 10 Rectifying minor faults yourself. . . Insert and screw on upper and lower arms tightly. - In the event of frequent use of the Eco 50°C program (if available), from time to time select the Intensive 70°C program (if available). - The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see page 8, “Maintenance and care“). - The spray arms must be able to turn freely and must not be impeded by crockery or cutlery. - Set “Tablet” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 3, “How to set water hardness”). - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. Try releasing the door 5 minutes before removing the dishes. - Arrange crockery so that water does not collect in cavities. [. . . ] - Be careful when the door is open: risk of tripping!- The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it. - Sharp items that might cause injury (e. g. [. . . ]