User manual WHIRLPOOL GSXK 5000 PRODUCT FICHE

[. . . ] RESET BUTTON For programme change or indication of faults. Press this button to cancel a started programme and selected extra options. Press this button to cancel the main fault indicators “F. . ” also refer to the chapter “What to do if. . . ”. The programme can then be selected and started. [. . . ] The wash cycle can be interrupted at any time by pressing RESET (see chapter “What to do if. . . ”). Change the programme in progress: • • • • • • Press the RESET button. Press the START button. Switch off the appliance Everything o. k. . . . Exercise caution when opening the door: beware of hot steam. Only press the OFF button once the START indicator lamp has switched off. Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below. Maintenance and care Maintenance and care Screw on filter cylinder NOTE MARK!Unscrew filter cylinder, remove it and fine sieve. . . Insert Filters Check and clean if necessary Rectifying minor faults yourself . . . 10 Insert and screw on lower and upper arms tightly. Clean spray nozzles under running water (use toothpicks if necessary) . . . Spray arms Remove blockages/ deposits. GB -5- What to do if. . . If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. . . . is not working/will not start . . . shows “F1” on the display or the START indicator lamp flashes once . . . shows “F4” on the display or the START indicator lamp flashes 4 times . . . shows “F6” on the display or the START indicator lamp flashes 6 times . . . shows “F7” on the display or the START indicator lamp flashes 7 times . . . shows “F8” on the display or the START indicator lamp flashes 8 times Possible causes. . . Not conform of glasses to washing in dishwashers (porcelain). - Set “Detergent type” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 2 “How to set water hardness”). - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long time after end - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. when using “delayed start” option). releasing the door 5 minutes before removing the dishes. Incorrect arrangement of the concave items in the rack. - Arrange crockery so that water does not collect in cavities. - Increase the dosage of rinse aid - see page 3, “Adding rinse aid”. [. . . ] - The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it. - Sharp items that might cause injury (e. g. knives), must be placed in the cutlery basket with the sharp end facing downwards. [. . . ]