User manual WHIRLPOOL GSXK 5011 A PRODUCT FICHE

[. . . ] With “Delayed start” selected it indicates the time remaining until program start (h. 00) - below 1h (0:min). If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if. . . ”. SALT INDICATOR When lit (at the end of the cycle), the salt reservoir needs to be refilled. RINSE AID INDICATOR When lit (at the end of the cycle), the rinse aid dispenser needs to be refilled. GSXK 5011 A 5019 496 01665 PROGRAMS SELECTION BUTTON Push “Programs” button (repeatedly) until the indicator of the required program lights up (see “Table of programs” next page). POWER CLEAN Thanks to the additional power jets this option provides a more intensive and powerful wash in the lower rack, in the specific area. [. . . ] possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1). Choose program according to the attached Table of programs (page 2). Duration of the program depends on the external conditions in the apartment, temperature and pressure etc. Wash cycle The dishwasher door must be closed and the water tap open. if you want to insert an item): - Open the door with caution (the program pauses) and insert the item/s, (beware of HOT steam!). - Press the START button and close the door within 3 seconds (the program resumes the cycle from where it was interrupted). To Cancel the program on running: - Open the door, press the CANCEL/ Off button and close the door. - (Water drains for up to 1 minute then the appliance switches off). To change the program in progress: - Open the door, press the CANCEL/Off button to cancel the running program and close the door. - (Water drains for up to 1 minute then the appliance switches off). - Open the door and press any button except CANCEL/Off button to switch on the appliance. . . . are not dry - Plastic containers dry badly. - Clean dishes left in dishwasher for a long time after end of cycle (e. g. when using “Delayed start” option). - Incorrect arrangement of the concave items in the rack. - In the event of frequent use of the Eco 50°C program (if available), from time to time select the Intensive 70°C program (if available). - The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see page 8, “Maintenance and care“). - The spray arms must be able to turn freely and must not be impeded by crockery or cutlery. - Set “Tablet” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 3, “How to set water hardness”). - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. [. . . ] - Be careful when the door is open: risk of tripping!- The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it. - Sharp items that might cause injury (e. g. [. . . ]