User manual WHIRLPOOL GU150ESJB PROGRAM CHART

[. . . ] After loading the dishwasher, close the door properly. Ensure that the water supply is turned on. The dishwasher switches on automatically as soon as the cycle selector knob is turned. One of the cycle indicator lamps will switch on. [. . . ] At this time, all the indicator lights will switch off. Open the door slowly (beware of hot steam). Unload the lower rack before the upper one. • • • Upper and lower rack To lower: pull out the two side handles and gently lower the rack. To raise: pull up the two side handles until the rack clicks into place. Up: plates. Lower rack A A Cup holders: • Upper rack • C Plate holder tines: • (A) may be lowered to increase available space. Glass holder: Cutlery basket: • The cutlery basket (C) can be removed to increase available space when necessary. Rack height adjustment: (The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded. C Please read the user instructions carefully. Troubleshooting Guide Tips and advice • Arrange dishes so that items do not touch each other. Arrange large dishes in the lower rack and smaller ones in the upper rack. Load cups at an angle to facilitate water drainage. Generally speaking, place cutlery in the basket with the handles positioned downwards, but ensure that any sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. Make sure the water jet can reach all loaded items and that the spray arms turn freely. • Before starting a wash cycle, make sure that the spray arms can turn freely and are not impeded by dishes or cutlery. Only switch off the dishwasher once the “Start” indicator lamp has switched off. If the dishwasher is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted without having to start it again. Dishes still dirty after washing: • Were the dishes loaded properly?• Dishes must be loaded facing downwards; this is important, especially for large dishes. • The water jets must spray the entire surface of all items. • Make sure that dishes and cutlery are arranged properly. • Have you selected the correct cycle?• Did you use too much or too little detergent?(The use of poor quality detergents may result in less effective washing). • Are the filters clogged or incorrectly assembled? [. . . ] If a fault occurs or if you wish to change the current cycle, press and hold the "start" button for about 5 seconds until the start indicator light switches off. • • If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket?• Has the Start button been pressed?• Has the delayed start timer been set (if fitted)?• Is the flow of water obstructed by impurities? [. . . ]