User manual WHIRLPOOL GU2800XTVY INSTALLATION

[. . . ] Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] NOTE: Do not remove tech sheet from access panel. Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. Using a ¹/" hex head socket, nut driver or Phillips screwdriver, remove terminal box cover. Be sure to fasten the insulation down on both sides of the tub. Put dishwasher on its back Make sure screwheads are facing to the left when tightening conduit nut. Strain relief may be provided with the power supply cord kit. Helpful Tip: Place cardboard under dishwasher until installed in cabinet opening to avoid damaging floor covering. Do not use door panel as a worktable without first covering with a towel to avoid scratching the door panel. Using two or more people, grasp sides of dishwasher door frame and place dishwasher on its back. What type of electrical connection will you use?If using Option B, proceed to "Determine Cabinet Opening, " to continue with the installation of your dishwasher. Connect ground wire to green ground connector in terminal box. Failure to follow these instructions can result in death, fire, or electrical shock. Power Cord--Route cord into terminal box Power Supply Cord-- Connect ground wire Remove the green grounding screw and place through the ring terminal of the green ground wire. Route cord so that it does not touch dishwasher motor to lower part of dishwasher tub. Pull cord through strain relief in terminal bow. Gently tug on wires to be sure both are secured. Connect wires black to black and white to white, using UL Listed/CSA Approved twist-on wire connectors. Power supply wire: white black ground wire Terminal box wire: white black ground connector If needed, see website for animated representation of this step. Measure height of cabinet opening from underside of countertop to floor where dishwasher will be installed (you will need to measure the lowest point on the underside of the countertop and the highest point on the floor). Refer to "Dishwasher Height Adjustment Chart" for wheel position and the number of turns needed. [. . . ] On some models there is insulation on the access panel which must fall behind the insulation on the lower panel. Read the Dishwasher User Instructions that came with your Check that all parts have been installed and no steps were Do not remove ground prong. Failure to follow these instructions can result in death, fire, or electrical shock. Start dishwasher and allow it to complete the shortest wash cycle. [. . . ]