User manual WHIRLPOOL GW397LXUS INSTALLATION GUIDE

[. . . ] W10526075A RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] Failure to follow these instructions can result in death, fire, or electrical shock. Use a flashlight to look underneath the bottom of the range. Visually check that the rear range foot is inserted into the slot of the anti-tip bracket. IMPORTANT: If there is a snapping or popping sound when lifting the range, the range may not be fully engaged in the bracket. Check to see if there are obstructions keeping the range from sliding to the wall or keeping the range foot from sliding into the bracket. Verify that the bracket is held securely in place by the mounting screws. Slide the range forward, and verify that the anti-tip bracket is securely attached to the floor or wall. Slide range back so the rear range foot is inserted into the slot of the anti-tip bracket. IMPORTANT: If the back of the range is more than 2" (5. 1 cm) from the mounting wall, the rear range foot may not engage the bracket. Slide the range forward and determine if there is an obstruction between the range and the mounting wall. If you need assistance or service, refer to the “Assistance or Service” section of the Use and Care Guide, or the cover or “Warranty” section of the User Instructions, for contact information. Repeat steps 1 and 2 to ensure that the range foot is engaged in the anti-tip bracket. If the rear of the range lifts more than ½" (1. 3 cm) off the floor without resistance, the anti-tip bracket may not be installed correctly. Do not operate the range without anti-tip bracket installed and engaged. Please reference the “Assistance or Service” section of the Use and Care Guide, or the cover or “Warranty” section of the User Instructions, to contact service. Place level on rack and check levelness of range, first side to side; then front to back. Place the outside of your foot against the bottom front of the warming drawer to keep the range from moving, and grasp the control panel with two hands as shown. If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket. Use wrench to adjust leveling legs up or down until range is level. NOTE: Range must be level for satisfactory baking performance. [. . . ] Remove the oven broil burner from the oven broil burner orifice hood. The oven broil burner will hang in the back of the oven while changing the orifice hood. Using an adjustable wrench, turn the Number . Using a Phillips screwdriver, remove the burner base. [. . . ]