User manual WHIRLPOOL GXW7330DXS

[. . . ] 4 CM) WALL-MOUNT CANOPY RANGE HOOD Installation Instructions and Use & Care Guide For questions about features, operation/performance parts, accessories or service, call: 1-800-253-1301 In Canada, for assistance, installation and service, call: 1-800-807-6777 or visit our website at. 27 RANGE HOOD SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. [. . . ] – If the house has aluminum wiring, follow the procedure below: 1. Connect the aluminum wiring to the added section of copper wire using special connectors and/or tools designed and UL listed for joining copper to aluminum. follow the electrical connector manufacturer's recommended procedure. Aluminum/copper connection must conform with local codes and industry accepted wiring practices. – Wire sizes and connections must conform with the rating of the appliance as specified on the model/serial rating plate. The model/serial plate is located behind the filter on the rear wall of the range hood. Wire sizes must conform to the requirements of the National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22. – 6 INSTALLATION INSTRUCTIONS Prepare Location ■ It is recommended that the vent system be installed before hood is installed. Before making cutouts, make sure there is proper clearance within the ceiling or wall for exhaust vent. Check your ceiling height and the hood height maximum before you select your hood. 8 mm) pilot holes at all locations where screws are being installed into wood. 4 mm) gap between the wall and the back of the screw head to slide range hood into place. Determine which venting method to use: roof, wall, or nonvented. Select a flat surface for assembling the range hood. Vent Cover Support Bracket Installation WARNING Excessive Weight Hazard Use two or more people to move and install range hood. Failure to do so can result in back or other injury. Using 2 or more people, lift range hood onto covered surface. Installations using telescoping upper and lower vent cover assembly 1. Position vent cover bracket on wall about ¹⁄₈" (3. 5 mm) holes for wall anchors and insert anchors flush with the wall. a B C Range Hood Mounting Screws Installation 5. Determine and mark the centerline on the wall where the canopy hood will be installed. [. . . ] Service calls to correct the installation of your major appliance, to instruct you on how to use your major appliance, to replace or repair house fuses, or to correct house wiring or plumbing. Service calls to repair or replace appliance light bulbs, air filters or water filters. Consumable parts are excluded from warranty coverage. Repairs when your major appliance is used for other than normal, single-family household use or when it is used in a manner that is contrary to published user or operator instructions and/or installation instructions. [. . . ]