User manual WHIRLPOOL GXW7336DX

[. . . ] For questions about features, operation/performance parts, accessories or service, call: 1-800-253-1301 In Canada, for assistance, installation and service, call: 1-800-807-6777 or visit our website at. Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. [. . . ] The following example falls within the maximum recommended vent length of 35 ft (10. To calculate the length of the system you need, add the equivalent feet (meters) for each vent piece used in the system. If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. A copy of the above code standards can be obtained from: National Fire Protection Association One Batterymarch Park Quincy, MA 02269 CSA International 8501 East Pleasant Valley Road Cleveland, OH 44131-5575 A 120 volt, 60 Hz. If the house has aluminum wiring, follow the procedure below: 1. Aluminum/copper connection must conform with local codes and industry accepted wiring practices. Wire sizes and connections must conform with the rating of the appliance as specified on the model/serial rating plate. The model/serial plate is located behind the filter on the rear wall of the range hood. Before making cutouts, make sure there is proper clearance within the ceiling or wall for exhaust vent. Check your ceiling height and the hood height maximum before you select your hood. 8 mm) pilot holes at all locations where screws are being installed into wood. 4 mm) gap between the wall and the back of the screw head to slide range hood into place. Determine which venting method to use: roof, wall, or nonvented. Excessive Weight Hazard Use two or more people to move and install range hood. Failure to do so can result in back or other injury. Using 2 or more people, lift range hood onto covered surface. Installations using telescoping upper and lower vent cover assembly 1. Position vent cover bracket on wall about ¹/" (3. 5 mm) holes for wall anchors and insert anchors flush with the wall. 4 cm) above the range to the bottom of the hood. Tape template in place, aligning the template centerline and bottom of template with hood bottom line and with the centerline marked on the wall. Determine and make all necessary cuts in the wall for the vent system. [. . . ] iTEMS EXCLUDED FROM WARRANTY This limited warranty does not cover: 1. Service calls to correct the installation of your major appliance, to instruct you on how to use your major appliance, to replace or repair house fuses, or to correct house wiring or plumbing. Service calls to repair or replace appliance light bulbs, air filters or water filters. Consumable parts are excluded from warranty coverage. [. . . ]