User manual WHIRLPOOL GY397LXU INSTALLATION

[. . . ] Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] This cord contains 3 copper conductors with ring terminals or open-end spade terminals with upturned ends, terminating in a NEMA Type 10-50P plug on the supply end. Connectors on the appliance end must be provided at the point the power supply cord enters the appliance. This range is equipped with a CSA International Certified Power Cord intended to be plugged into a standard 14-50R wall receptacle. Be sure the wall receptacle is within reach of range's final location. The cooktop sides of the slide-in range fit over the cutout edge of your countertop. If you have a square finish (flat) countertop and the opening width is 30" (76. 0 cm) from each front corner of opening. Tile countertops may need trim cut back ³/" (1. 0 cm) from each front corner and/or rounded edge flattened. Failure to do so can result in death, fire, or electrical shock. If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate and wire gauge are in accordance with local codes. Be sure that the electrical connection and wire size are adequate and in conformance with CSA Standard C22. 1 , Canadian Electrical Code , Part 1 - latest edition , and all local codes and ordinances. A copy of the above code standards can be obtained from: Canadian Standards Association 178 Rexdale Blvd. If countertop opening width is greater than 30" (76. Place level on countertop, first side to side, then front to back. If countertop is not level, range will not be level. Range must be level for satisfactory baking conditions. Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. Remove oven racks and parts package from inside oven. A child or adult can tip the range and be killed. [. . . ] Use ³/" nut driver to connect the bare (green) ground wire to the center terminal block post with one of the 10­32 hex nuts. Connect line 1 (black) and line 2 (red) wires to the outer terminal block posts with 10-32 hex nuts. Making sure the anti-tip bracket is installed: Look for the anti-tip bracket securely attached to floor or wall. Attach terminal lugs to line 1 (black), bare (green) ground, and line 2 (red) wires. [. . . ]