User manual WHIRLPOOL HB 1 IH B INSTRUCTION FOR USE

[. . . ] • Ensure that the installation and electrical connections are performed by a qualified technician, following the manufacturer’s instructions and in compliance with current local safety regulations. CAUTION: This cooktop complies with all applicable safety and electromagnetic compatibility legislation. However, persons with pacemaker should keep at a safe distance from the appliance. This is because it is not possible to guarantee that all pacemakers on the market comply with the standards in compliance with which this appliance was tested so it is not possible to provide an absolute guarantee of the absence of potentially harmful interference. DECLARATION OF CONFORMITY DECLARATION OF CONFORMITY • This cooktop is suitable for contact with foodstuffs and complies with EEC (CE) Regulation n. [. . . ] TO OBTAIN THE BEST RESULTS: • Make sure you place the pot or pan in the centre of the cooking zone outlined on the glass ceramic induction hob. 61966017GB. fm Page 19 Tuesday, April 17, 2007 12:33 PM HOW TO USE YOUR HOB 1. Display 1 C 2 A B C Childproof Lock Cooking zone activation button Heat setting decrease A B C D E F D E Heat setting increase Timer ON/OFF F Operation Instructions 1. • Put the pot in the centre of the ceramic plate. • Make sure the air vent and the air entry are not blocked and there are not metallic objects around the hot plate. Plug in After the power on, the buzzer sounds. Turn on • When the “on/off” button is pressed, the buzzer sounds. The “ ” indicator lamp lights up, the LED display “--”, indicating that the hotplate is in the state of stand-by. • If you don’t press any key within 2 minutes, the induction hotplate will shut down automatically. Heating • After the power supply is connected, press the “ ” button, then press the “ ” button, the buzzer sounds, the “ ” and the “ ” indicator lamp light up, the default power level shall be level 4, you can tune the power level to the max. level by holding the “ ” key. • You can make a regulation by pressing the “ ” or “ ” key. Childproof Lock • When the hotplate is in working state, to prevent children from operation, you can activate the childproof lock by pressing the childproof lock button, the buzzer will sound at the same time. In the childproof lock state, “Childproof Lock” button and “ ” button can be operated, other buttons are non effective. • You can deactivate the childproof lock by holding the childproof button again. Timer • In working state, after the “ ” key is pressed, the buzzer gives out a sound, the maxi tube flashes and displays “0”, indicating that the induction hotplate enters timing setting state. Each time the “ ” or “ ” key is pressed, the time can increase or decrease by 1 minute. If it is held, the time will increase or decrease quickly with 10 minutes as an increment. When the timer is max. , then press the “ ” key, the time will resume min. When the timer is min. , then press the “ ” key, the time will resume max. • After timing period is set, the time stabilizes after the nixie tube flashes for 5 seconds to confirm the period to be effective. If the time is 0, the timer is non effective. • In the timing setting state, pressing the timer button again will confirm the time. [. . . ] Make sure that the voltage indicated on the rating plate corresponds to the voltage in your home. The manufacturer declines all liability for injury to persons and animals or damage to property resulting from failure to observe the above regulations. For the electrical connection use a HO5VV-F or HO5V2V2-F type cable as indicated in the table below: Power supply voltage Conductors (number and size) 230 V 2 X 1. 0 mm2 min. An all-pole disconnect switch with minimum contact gap equal to or greater than 3 mm must be used to install the hob. Attention: the power supply cable must be long enough to allow the hob to be removed from the worktop and must be positioned so as to avoid damage or overheating caused by contact with the base. [. . . ]