User manual WHIRLPOOL HB 402 S INSTRUCTION FOR USE

[. . . ] • Ensure that the installation and electrical connections are performed by a qualified technician, following the manufacturer’s instructions and in compliance with current local safety regulations. SUGGESTIONS FOR ENVIRONMENT PROTECTION 1. Packaging The packaging material is entirely recyclable, and is marked with the recycling symbol , which identifies it as a type of material that must be sent to local waste-disposal centres. Product This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). [. . . ] • Wipe it with a cloth moistened with hot water and soap or diluted liquid detergent. • Do not use abrasive or corrosive products, chlorine products or steel wool. • Do not leave acid or alkaline substances, such as vinegar, salt or lemon juice, etc. , on the cooking hob. Stainless steel surface • Clean it with a specific commercial product. Note: if the cooking hob is used continuously, the high temperatures may alter the colour of the hotplates. Cleaning the electric hotplates The electric hotplates must be cleaned when they are lukewarm. Wipe them with a cloth moistened with water and salt, and polish with a cloth moistened with oil. 12 61963002GB. fm Page 13 Tuesday, July 12, 2005 10:49 AM TROUBLESHOOTING GUIDE The hob does not work: • Check for the presence of mains electrical power. • Set the knob to “0” and switch on the hob again to ensure that the fault has been remedied. The hob does not turn off: • disconnect the hob immediately by disconnecting the power cable from the socket. AFTER SALES SERVICE Before you call the After Sales Service: 1. Re-start the cooktop, to check whether correct operation has been restored. If the malfunction persists, call the After Sales Service. Give the following information: • type of malfunction; • model of cooktop; • service number (i. e. , the number that follows the word SERVICE on the rating plate under the cooktop and on the guarantee paper); • your complete address; • your telephone number and area code. If any repairs are required, please contact an authorised After-Sales Service, as indicated in the warranty. In the unlikely event that an operation or repair is carried out by an unauthorised technician, always request a certification of the job carried out and insist on the use of original spare parts. Failure to comply with these instructions may compromise the safety and quality of the product. 13 61963002GB. fm Page 14 Tuesday, July 12, 2005 10:49 AM INSTALLATION Technical information for the Installer This cooking hob can be embedded in a worktop 20 to 50 mm thick. If another appliance is not fitted under the cooking hob, insert a separator panel, at a distance of at least 90 mm from the cooking hob bottom. [. . . ] Open the cover of the terminal board and loosen screw by means of a tool, as shown in the figure. Peel off the internal cables for about 10 mm loosen cable clamp screw , and insert the cable in the cable clamp. • The terminal board has 4 terminals: 1-2 interconnected (line) 3 (neutral) 4 (earth): marked with symbol . [. . . ]