User manual WHIRLPOOL HD F10 S INSTALLATION

[. . . ] All other maintenance operations must be carried out by a qualified technician. • When drilling through the wall pay attention not to damage electric connections and/or pipes: • Air vents must always discharge to the outside. • The manufacturer rejects all responsibilities for any damage caused by improper use or wrong settings. • Appropriate maintenance and cleaning ensure the good working order and the best performance of the appliance. [. . . ] Before scrapping, cut off the power supply cable. • For further information on the treatment, recovery and recycling of household electrical appliances, contact your competent local authority, the collection service for household waste or the store where you purchased the appliance. KEEP THIS BOOKLET FOR FUTURE CONSULTATION. GB3 PRELIMINARY ASSEMBLY INSTRUCTIONS The hood has been designed to be installed and used either as a "Suction Model", or as a "Filter Model". symbol in the installation booklet) Suction model (see Cooking steam is sucked and channelled outside the house through a discharge duct (not supplied), fitted to the hood steam outlet. Ensure that the discharge duct is correctly fitted to the air outlet, unit using an appropriate connection system. Important: If already installed, remove the carbon filter/s. Filter model (see symbol in the installation booklet) The air is filtered through one or more the carbon filters, and then resent into the room. Important: Ensure appropriate air circulation around the hood. Important: If the hood is supplied without carbon filters, these must be ordered and fitted before the hood can be used. The hood should be installed away from particularly dirty areas, windows, doors and heat sources. The hood is sold with all necessary components for installation on most types of walls or ceilings. If after the above checks the fault still occurs, get in touch with the nearest After-sales Service. Always specify: • a brief description of the fault; • the exact type and model of the appliance; • the service number (number after the word Service on the rating plate), located on the inside of the appliance. The service number is also indicated on the guarantee booklet; • your full address; • your telephone number. If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). GB5 CLEANING WARNING: Never use steam cleaning equipment. Disconnect the appliance from the power supply. IMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. • Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. Finish off with a dry cloth. IMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. Over time, these can ruin the enamel surface. • Use detergents specifically designed for cleaning the appliance and follow the manufacturer instructions. IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals. DESCRIPTION OF THE HOOD 1. ON/OFF light key Press briefly to switch the lights on and off. [. . . ] This will not cause any reduction of performance. To remove the filter pull out the handle. After the filter has been washed and dried, replace following the inverse procedure. REPLACING THE ALOGEN LAMPS IMPORTANT: - Only use 12V 20W 30° Ø35 12V GU4 halogen lamps. 1. Disconnect the hood from the electric power supply. [. . . ]