User manual WHIRLPOOL HD F40 S INSTALLATION

[. . . ] To avoid any damage do not place any weights on the appliance. Do not expose the appliance to atmospheric agents. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others. [. . . ] If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, a qualified electrician should install a standardised double pole power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with wiring rules. ENGLISH 6 Use The hood has been designed to be installed and used either as a “Exhausted model”, or as a “Recirculation model”. in Exhausted model (see symbol installation booklet) Cooking steam is sucked and channelled outside the house through a discharge duct (not supplied), fitted to the hood steam outlet. Ensure that the discharge duct is correctly fitted to the air outlet, unit using an appropriate connection system. Important: If already installed, remove the charcoal filter/s. in Recirculation model (see symbol installation booklet) The air is filtered through one or more the charcoal filters, and then resent into room. Important: Ensure appropriate air circulation around the hood. Important: If the hood is supplied without charcoal filters, these must be ordered and fitted before the hood can be used. The hood should be installed away from particularly dirty areas, windows, doors and heat sources. The hood is sold with all necessary components for installation on most types of walls or ceilings. However, ask a qualified technician to check that the items supplied are suitable for the type of wall/ceiling. Keep this booklet for future consultation. ENGLISH 7 Product description 3 1 3 1 Control Panel. Disconnect the hood from the electric power supply. Check that the R pins on the conveyor correspond with the S holes. Turn the filters to lock them to the pins. To remove the filters follow the inverse procedure. Replace the grease filters. 2x S S R ENGLISH 10 What to do if . . . Problem The appliance does not work Possible cause There is no mains elctrical power Solution Check for the presence of mains electrical power. Turn off the appliance and restart it to see if the faults persists. Check if the appliance is connected to the electrical supply. Turn off the appliance and restart it to see if the faults persists. Check the suction speed and adjust as necessary Check that the filters are clean If not, clean the filters in the dishwasher. Check the air vents for any obstructions and remove as necessary. Check the light bulb and replace it if necessary. [. . . ] • Deliberate or negligent damage, damage caused by failure to observe operating instructions, incorrect installation or by connection to the wrong voltage, damage caused by chemical or electrochemical reaction, rust, corrosion or water damage including but not limited to damage caused by excessive lime in the water supply, damage caused by abnormal environmental conditions. • Consumable parts including batteries and lamps. • Non-functional and decorative parts which do not affect normal use of the appliance, including any scratches and possible color differences. • Accidental damage caused by foreign objects or substances and cleaning or unblocking of filters, drainage systems or soap drawers. [. . . ]