User manual WHIRLPOOL HD R00 B INSTRUCTION FOR USE

[. . . ] For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. WARNING: To reduce the risk of accidents, electric shock, injury or damage, when using the hood comply with the basic precautions, including the following. Always disconnect the hood from the power supply before carrying out any installation or maintenance operation on the appliance. Installation must be carried out by a specialised technician, in compliance with the manufacturer’s instructions and local safety regulations. [. . . ] Do not use or leave the hood without its lamps correctly installed - risk of electric shock. Wear work gloves for all installation and maintenance operations. The product is not suitable for outdoor use. The air sucked by the hood must not be eliminated through the same flue of the heating system or other appliances using gas or other fuels. GB User and Maintenance Handbook Also contains instructions and regulations for safe installation Before installing or using the hood, carefully read and follow the instructions given in this handbook and in the enclosed installation handbook. WARNING: Be sure to observe the minimum installation distance from cookers, which is indicated in the installation handbook. If the installation instructions for the gas cooker specify a greater distance, this must be taken into account. 5019 618 33117/A LI3I2A The mains voltage must match that given on the rating plate located inside the hood. If provided with a plug, connect the hood to a socket complying with the current regulations and located in an accessible area. If it does not have a plug (direct connection to the power supply) or if the plug is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. WARNING: Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. Make sure to have this operation carried out by a specialised technician. Electrical connection Cleaning the hood WARNING: Failure to remove oil/grease (at least once a month) could result in fire. Use a soft cloth with a neutral detergent. never use abrasive substances or alcohol. Before using the hood Please read these instructions carefully and keep them for future reference, in order to ensure best use of your hood. the packing materials (plastic bags , polystyrene , etc. ) are a potential source of danger and must be kept out of the reach of children. [. . . ] 1 Grease filters: The metal grease filter has an unlimited life and must be washed once a month by hand or in a dishwasher at a low temperature and with short cycle. Washing in a dishwasher can cause the grease filter to become opaque, but its filtering capacity is not affected. 2); to do so, pull the spring release handle (f1) then remove the filter/s (f2). 2 (for models with filter installation): The carbon filter must be washed once a month in a dishwasher at the highest temperature, using a normal dishwasher detergent. [. . . ]