User manual WHIRLPOOL HD TS40 40S INSTRUCTION FOR USE

[. . . ] Carefully observe the following instructions. Precautions and general recommendations • The electrical installation and the electrical connection must be carried out by a qualified technician according to the manufacturer’s instructions and in compliance with the local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. The appliance must be disconnected from the power supply before carrying out any installation work. [. . . ] Before installation also check the minimum distances stated in the manual of the cooker. If the installation instructions for the cooker specify a greater distance between cooker and hood, this distance must be observed. Electrical connection Make sure the power voltage specified on the appliance rating plate is the same as the mains voltage. This information can be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 VV-F) must be carried out by a qualified electrician. If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place. If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, a qualified electrician should install a standardised double pole power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with wiring rules. eNGLISH 6 Use The hood has been designed to be installed and used either as a “Exhausted model” , or as a “Recirculation model”. In Exhausted model (see symbol the installation booklet) Cooking steam is sucked and channelled outside the house through a discharge duct (not supplied), fitted to the hood steam outlet. Ensure that the discharge duct is correctly fitted to the air outlet, unit using an appropriate connection system. Important: If already installed, remove the charcoal filter/s. Recirculation model (see symbol in the installation booklet) The air is filtered through one or more the charcoal filters, and then resent into room. important: Ensure appropriate air circulation around the hood. Important: If the hood is supplied without charcoal filters, these must be fitted before the hood can be used. The hood should be installed away from particularly dirty areas, windows, doors and heat sources. The accessories for wall fixing are not included because walls made of different materials require different types of fixing accessories. Use fixing systems suitable for the walls of your home and the weight of the appliance. for more details , contact a specialized dealer. Keep this booklet for future consultation. - Disconnect the appliance from the power supply. iMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. [. . . ] ENGLISH 1 1 Technical data Width Dimensions - Internal (mm) Airflow max - Exhaust (m /h) 3 430 1 150 430 608 66, 9 252 68, 5 275 2x 10W 26, 35 Height Depth Noise max - Exhaust (dBa) Airflow max - Recirculating (m3/h) Noise max - Recirculating (dBa) Total Power (W) Lamps Weight (Kg) Installation minimun height dimensions (cm) gas or combi cookers electric cookers 65 50 The technical information is situated on the rating plate in the internal side of the appliance. eNGLISH 12 Environmental concerns Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol . The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal. Scrapping the product - This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). [. . . ]