User manual WHIRLPOOL HD U10 S INSTALLATION

[. . . ] All other maintenance operations must be carried out by a qualified technician. • When drilling through the wall pay attention not to damage electric connections and/or pipes: • Air vents must always discharge to the outside. • The manufacturer rejects all responsibilities for any damage caused by improper use or wrong settings. • Appropriate maintenance and cleaning ensure the good working order and the best performance of the appliance. [. . . ] • During all installation and maintenance operations wear appropriate working gloves. • This appliance is not suitable for outdoor use. Scrapping of household appliances • This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations. Before scrapping, cut off the power supply cable. • For further information on the treatment, recovery and recycling of household electrical appliances, contact your competent local authority, the collection service for household waste or the store where you purchased the appliance. KEEP THIS BOOKLET FOR FUTURE CONSULTATION. GB9 PRELIMINARY ASSEMBLY INSTRUCTIONS The hood has been designed to be installed and used either as a "Suction Model", or as a "Filter Model". Suction model (see symbol in the installation booklet) Cooking steam is sucked and channelled outside the house through a discharge duct (not supplied), fitted to the hood steam outlet. Ensure that the discharge duct is correctly fitted to the air outlet, unit using an appropriate connection system. Important: If already installed, remove the carbon filter/s. Filter model (see symbol in the installation booklet) The air is filtered through one or more the carbon filters, and then resent into the room. • Turn off the appliance and restart it to see if the fault persists. The hood's suction level is not sufficient: • Check the suction speed and adjust as necessary: • Check that the filters are clean: • Check the air vents for any obstructions; The light does not work; • Check the light bulb and replace if necessary; • Check that the light bulb has been correctly fitted; AFTER-SALES SERVICE Before calling the After-Sales Service: 1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide". Switch the appliance off and back on again it to see if the fault persists. If after the above checks the fault still occurs, get in touch with the nearest After-sales Service. Always specify: • a brief description of the fault; • the exact type and model of the appliance; • the service number (number after the word Service on the rating plate), located on the inside of the appliance. The service number is also indicated on the guarantee booklet; • your full address; • your telephone number. If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). GB11 CLEANING WARNING: - Never use steam cleaning equipment. - Disconnect the appliance from the power supply. IMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. • Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. [. . . ] If washed in the dishwasher, the grease filter surface may become matt. This will not cause any reduction of performance. • To remove the filter pull out the handle. After the filter has been washed and dried, replace following the inverse procedure. REPLACING THE LAMPS 1. [. . . ]