User manual WHIRLPOOL HD UR40 60S INSTRUCTION FOR USE

[. . . ] Carefully observe the following instructions. Precautions and general recommendations • The electrical installation and the electrical connection must be carried out by a qualified technician according to the manufacturer’s instructions and in compliance with the local safety Safety Information • • • • • • • • • • • regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. The appliance must be disconnected from the power supply before carrying out any installation work. [. . . ] Before installation also check the minimum distances stated in the manual of the cooker. If the installation instructions for the cooker specify a greater distance between cooker and hood, this distance must be observed. Electrical connection Make sure the power voltage specified on the appliance rating plate is the same as the mains voltage. This information can be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 VV-F) must be carried out by a qualified electrician. If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place. If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, a qualified electrician should install a standardised double pole power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with wiring rules. Use The hood has been designed to be installed ENGLISH 6 and used either as a “Exhausted model”, or as a “Recirculation model”. Exhausted model (see symbol in installation booklet) Cooking steam is sucked and channelled outside the house through a discharge duct (not supplied), fitted to the hood steam outlet. Ensure that the discharge duct is correctly fitted to the air outlet, unit using an appropriate connection system. Important: If already installed, remove the charcoal filter/s. Recirculation model (see symbol in installation booklet) The air is filtered through one or more the charcoal filters, and then resent into room. important: Ensure appropriate air circulation around the hood. Important: If the hood is supplied without charcoal filters, these must be fitted before the hood can be used. The hood should be installed away from particularly dirty areas, windows, doors and heat sources. The hood is sold with all necessary components for installation. However, ask a qualified technician to check that the items supplied are suitable for the type of wall/ ceiling. Keep this booklet for future consultation. eNGLISH 7 Product description 3 1 3 1 Control Panel. 2 Grease filter (above the perimeter suction filter) 3 Halogen bulbs 4 Perimeter suction panel 4 2 Control panel A operating gauge B on/off light switch C on/off aspiration switch and minimum power selection C + D medium power selection aspiration switch C + E maximum power selection aspiration switch A B C D E ENGLISH 8 Cleaning and maintenance WARNING: - Use safety gloves. - Disconnect the appliance from the power supply. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. [. . . ] eNGLISH 12 Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol . The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal. Scrapping the product - This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). - By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ]