User manual WHIRLPOOL HD VM10 90AN INSTRUCTION FOR USE

[. . . ] VINDRUM GB ENGLISH 4 ENGLISH 4 Safety information Product description Control panel Cleaning and maintenance What to do if . . . Contents Before first use Your safety and that of others is paramount. Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. [. . . ] 4 Grease filter. 2 3 4 Control panel A Light ON/OFF button. B Motor ON/OFF button / Extraction power 1 selection button C Extraction power 2 selection button D Extraction power 3 selection button E Lamp indicator E A B C D Cleaning and maintenance WARNING: - Never use steam cleaning equipment. - Disconnect the appliance from the power supply. IMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. • Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. IMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. • Use detergents specifically designed for cleaning the appliance and follow the manufacturer instructions. IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals. ENGLISH 8 To clean the grease filter The metal grease filter has an unlimited life and must be washed once a month by hand or dishwasher at low temperature and with a short cycle. With cleaning in a dishwasher the grease filter may become dull; this does not effect its filtering capacity. Grease filter maintenance: 1. Disconnect the hood from the electric power supply. 2 Remove the grease filters: pull the spring release handle downwards, then remove the filter. 3. After cleaning the grease filter, remount in reverse order ensuring the entire extraction surface is covered. Charcoal filter maintenance (if the hood is installed in recirculation mode) 1. Remove the grease filters. 2. Fit (bayonet attachment) 1 adaptor each conveyour side. 3. Fit (bayonet attachment) 1 charcoal filter each conveyour side. 4. Reverse the above procedure to remove the charcoal filter. 5. Refit the grease filters, Charcaol filter is neither lavable nor regenerable. Replace it every 4 months. Lamp maintenance Disconnect the hood from the electricity. Warning Prior to touching the light bulbs ensure they are cooled down. Use a small screwdriver or other suitable tool to prise off the cover. Important: make sure you don’t touch the lamp with your bare hands. ENGLISH 9 What to do if . . . Problem The appliance does not work Possible cause There is no mains electrical power Solution Check for the presence of mains electrical power. [. . . ] Unless such damages can be proved to have been caused by production faults. • Cases where no fault could be found during a technician’s visit. • Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used. • Repairs caused by installation which is faulty or not according to specification. [. . . ]