User manual WHIRLPOOL HDD W10 S INSTRUCTION FOR USE

[. . . ] DATID HW570 GB ENGLISH 4 ENGLISH 4 Safety information Product description Control panel Cleaning and maintenance What to do if . . . Contents 4 7 7 7 9 Technical data Environmental concerns Electrical connection for Great Britain and Ireland only IKEA GUARANTEE 10 1 1 12 13 Before first use Your safety and that of others is paramount. Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. [. . . ] 5 Ladle holder. 2 4 3 4 5 Control panel A Light switch: move right to switch the light on. B Suction power selection switch: move right to switch on and to select the desired power/speed 0 1 0 1 2 3 A B Cleaning and maintenance WARNING: - Never use steam cleaning equipment. - Disconnect the appliance from the power supply. IMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. • Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. IMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. • Use detergents specifically designed for cleaning the appliance and follow the manufacturer instructions. IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals. To clean the grease filter The metal grease filter has an unlimited life and must be washed once a month by hand or dishwasher at low temperature and with a short cycle. With cleaning in a dishwasher ENGLISH 8 the grease filter may become dull; this does not effect its filtering capacity. Grease filter maintenance: 1. Unplug the appliance or disconnect the power supply. 2. Remove the grease filters: pull the spring release handle, then remove the filter downwards. 3. After cleaning the grease filter, remount in reverse order ensuring the entire extraction surface is covered. Replacing the Halogen lamps WARNING: - Only use 20W MAX - G4 halogen lamps. 1. Disconnect the hood from the electric power supply. 2. Insert the blade of a small flat screwdriver where indicated by the three points, and with a gentlepressure remove the light cover from its position. 3. Remove the faulty lamp and replace with a new one. 4. Replace the cover (spring lock system). IMPORTANT: make sure you don’t touch the lamp with your hands. Charcoal filter maintenance 1. Unplug the appliance or disconnect the power supply. 2. Remove the grease filter 3. If charcoal filters are already present (two filters fitted, covering the protection grids of the motor impeller) and must be replaced, turn the central handle anticlockwise to unlock them. [. . . ] • Damage to the following parts: ceramic glass, accessories, crockery and cutlery baskets, feed and drainage pipes, seals, lamps and lamp covers, screens, knobs, casings and parts of casings. Unless such damages can be proved to have been caused by production faults. • Cases where no fault could be found during a technician’s visit. • Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used. [. . . ]