User manual WHIRLPOOL HDF CW10 S INSTRUCTION FOR USE

[. . . ] FRAMTID HW400 GB ENGLISH 4 ENGLISH 4 Safety information Product description Control panel Cleaning and maintenance What to do if . . . Contents 4 7 7 7 9 Technical data Environmental concerns Electrical connection for Great Britain and Ireland only IKEA GUARANTEE 10 1 1 12 13 Before first use Your safety and that of others is paramount. Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. [. . . ] Keep this booklet for future consultation. ENGLISH 7 Product description 1 Control panel 2 Grease filter 3 Light 4 Chimney 4 1 3 3 2 Control panel A ON/OFF light switch B ON-OFF switch and suction level 1 activation C Suction power 2 selection switch D Suction power 3 selection switch A B C D Cleaning and maintenance WARNING: - Never use steam cleaning equipment. - Disconnect the appliance from the power supply. IMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. • Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. IMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. • Use detergents specifically designed for cleaning the appliance and follow the manufacturer instructions. IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals. ENGLISH 8 Grease filter The metal grease filter has unlimited duration. It should be washed at least once a month, either by hand, or in the dishwasher (use a short cycle and low temperature). If washed in the dishwasher, the grease filter surface may become matt. This will not have any effect on performance. To remove the filter, pull out the handle. After the filter has been washed and dried, replace following the inverse procedure. Fitting or replacing charcoal filter Charcoal filter is neither lavable nor regenerable. Replace the charcoal filter every 4 months 1. Disconnect the hood from the electric power supply. 3. If charcoal filters are already present (two filters fitted, covering the protection grids of the motorimpeller) and must be replaced, turn the central handle anticlockwise to unlock them. Replacing the lamps 1. Disconnect the hood from the electric power supply. 2. Insert the blade of a small flat screwdriver where indicated by the three points, and with a gentlepressure remove the light cover from its position. 3. Remove the faulty lamp and replace with a new one. 4. Replace the cover (spring lock system). [. . . ] • Damage to the following parts: ceramic glass, accessories, crockery and cutlery baskets, feed and drainage pipes, seals, lamps and lamp covers, screens, knobs, casings and parts of casings. Unless such damages can be proved to have been caused by production faults. • Cases where no fault could be found during a technician’s visit. • Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used. [. . . ]