User manual WHIRLPOOL HDF VW10 S INSTRUCTION FOR USE

[. . . ] All other maintenance operations must be carried out by a qualified technician. • When drilling through the wall pay attention not to damage electric connections and/or pipes: • Air vents must always discharge to the outside. • The manufacturer rejects all responsibilities for any damage caused by improper use or wrong settings. • Appropriate maintenance and cleaning ensure the good working order and the best performance of the appliance. [. . . ] • Before touching the light bulbs, ensure that they are cold. • Do not use or leave the hood without the light bulb correctly fitted, as this may cause electric shock. • The hood is not a worktop, therefore do not place any objects on top of it or overload it. • During all installation and maintenance operations wear appropriate working gloves. • This appliance is not suitable for outdoor use. Scrapping of household appliances • This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations. Before scrapping, cut off the power supply cable. • For further information on the treatment, recovery and recycling of household electrical appliances, contact your competent local authority, the collection service for household waste or the store where you purchased the appliance. KEEP THIS BOOKLET FOR FUTURE CONSULTATION. GB9 PRELIMINARY ASSEMBLY INSTRUCTIONS Filter model (see symbol in the installation booklet) The air is filtered through one or more the carbon filters, and then resent into the room. Important: Ensure appropriate air circulation around the hood. The hood's suction level is not sufficient: • Check the suction speed and adjust as necessary: • Check that the filters are clean: • Check the air vents for any obstructions; The light does not work; • Check the light bulb and replace if necessary; • Check that the light bulb has been correctly fitted; AFTER-SALES SERVICE Before calling the After-Sales Service: 1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide". Switch the appliance off and back on again it to see if the fault persists. If after the above checks the fault still occurs, get in touch with the nearest After-sales Service. Always specify: • a brief description of the fault; • the exact type and model of the appliance; • the service number (number after the word Service on the rating plate), located on the inside of the appliance. The service number is also indicated on the guarantee booklet; • your full address; • your telephone number. If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). GB11 CLEANING WARNING: Never use steam cleaning equipment. Disconnect the appliance from the power supply. IMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. • Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. Finish off with a dry cloth. IMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. [. . . ] use protective gloves. GREASE FILTER The metal grease filter has unlimited duration. It should be washed at least once a month, either by hand, or in the dishwasher (use a short cycle and low temperature). If washed in the dishwasher, the grease filter surface may become matt. This will not have any effect on performance. [. . . ]