User manual WHIRLPOOL HDF VW40 S INSTRUCTION FOR USE

[. . . ] Carefully observe the following instructions. Precautions and general recommendations • The electrical installation and the electrical connection must be carried out by a qualified technician according to the manufacturer’s instructions and in compliance with the local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual. The appliance must be disconnected from the power supply before carrying out any installation work. [. . . ] If the installation instructions for the cooker specify a greater distance between cooker and hood, this distance must be observed. Electrical connection Make sure the power voltage specified on the appliance rating plate is the same as the mains voltage. This information can be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 VV-F) must be carried out by a qualified electrician. If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place. If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, a qualified electrician should install a standardised double pole power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with wiring rules. eNGLISH 6 Use The hood has been designed to be installed and used either as a “Exhausted model” , or as a “Recirculation model”. Exhausted model (see symbol in installation booklet) Cooking steam is sucked and channelled outside the house through a discharge duct (not supplied), fitted to the hood steam outlet. Ensure that the discharge duct is correctly fitted to the air outlet, unit using an appropriate connection system. Important: If already installed, remove the charcoal filter/s. Recirculation model (see symbol in installation booklet) The air is filtered through one or more the charcoal filters, and then resent into room. important: Ensure appropriate air circulation around the hood. Important: If the hood is supplied without charcoal filters, these must be ordered and fitted before the hood can be used. The hood should be installed away from particularly dirty areas, windows, doors and heat sources. The hood is sold with all necessary components for installation on most types of walls or ceilings. However, ask a qualified technician to check that the items supplied are suitable for the type of wall/ceiling. Keep this booklet for future consultation. 2 2 3 Control panel A ON/OFF light switch Press briefly to switch the lights on and off. Press and hold down to adjust the light intensity. B ON-OFF switch and suction level 1 activation C Suction power 2 selection switch D Suction power 3 selection switch A B C D Cleaning and maintenance WARNING: - Never use steam cleaning equipment. - Disconnect the appliance from the power supply. iMPORTANT: do not use corrosive or abrasive detergents. [. . . ] If not, fit the light bulb in right way. The appliance is not connected to the electrical supply The hood’s suction level is not enough The suction speed is too low The metal filters are dirty The air vents are obstructed The light does not work The light bulb is broken The light bulb is not correctly fitted Before contacting the After-sales service: Switch the appliance on again to see if the problem has disappeared. If not, switch it off again and repeat the operation after an hour. If your appliance still does not work properly after carrying out the checks listed in the troubleshooting guide and switching the appliance on again, contact the Aftersales service, clearly explaining the problem and specifying: • the type of fault; • the model; • the type and serial number of the appliance (given on the rating plate); • the Service number (the number after the word SERVICE on the rating plate inside the appliance). [. . . ]